AzteegX5MiniV2_KlipperConfig

# Klipper config for Ender-3 and Azteeg X5 mini V2
# Prepared 27-April-2019

[stepper_x]
step_pin: P2.1
dir_pin: P0.11
enable_pin: P0.10
step_distance: 0.0015625
endstop_pin: ^!P1.24
position_endstop: 0
position_max: 230
homing_speed: 50

[stepper_y]
step_pin: P2.2
dir_pin: P0.20
enable_pin: P0.19
step_distance: 0.0015625
endstop_pin: ^!P1.26
position_endstop: 0
position_max: 210
homing_speed: 50

[stepper_z]
step_pin: P2.3
dir_pin: P0.22
enable_pin: P0.21
step_distance: 0.0003125
endstop_pin: ^!P1.28
position_endstop: 0
position_max: 220
homing_speed: 50

[extruder]
step_pin: P2.0
dir_pin: P0.5
enable_pin: P0.4
step_distance: 0.0041376
nozzle_diameter: 0.300
filament_diameter: 1.680
heater_pin: P2.7
sensor_type: ATC Semitec 104GT-2
sensor_pin: P0.24
control: pid
pid_Kp: 18.28
pid_Ki: 1.28
pid_Kd: 65.48
min_temp: 0
min_extrude_temp: 25
max_temp: 250
max_extrude_cross_section: 20
pressure_advance: 0.11
pressure_advance_lookahead_time: 0.015

[verify_heater extruder]
heating_gain: 2
check_gain_time: 25
hysteresis: 7.5
max_error: 240

[heater_bed]
heater_pin: P2.5
sensor_type: EPCOS 100K B57560G104F
sensor_pin: P0.23
control: pid
pid_Kp: 54.027
pid_Ki: 0.770
pid_Kd: 948.182
min_temp: 0
max_temp: 130

[fan]
pin: P0.26
cycle_time: 0.05
kick_start_time: 0.1

[mcu]
serial: /dev/serial/by-id/usb-Klipper_Klipper_firmware_12345-if00
baud: 250000

[printer]
kinematics: cartesian
max_velocity: 200
max_accel: 5000
max_z_velocity: 60
max_z_accel: 2000
max_accel_to_decel: 3000
square_corner_velocity: 6

[homing_override]
set_position_z: 5
gcode: G1 Z10 F500
       G28
axes: z

[virtual_sdcard]
path: ~/.octoprint/uploads/

[force_move]
enable_force_move: True