Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- U-Boot 2015.01 (Mar 15 2017 - 19:43:11)
- DRAM: 2 GiB
- Relocation Offset is: 76ecc000
- register usb cfg[0][1] = 0000000077f60198
- vpu: error: vpu: check dts: FDT_ERR_BADMAGIC, load default parameters
- vpu: clk_level = 7
- vpu: set clk: 666667000Hz, readback: 666660000Hz(0x300)
- vpp: vpp_init
- boot_device_flag : 1
- Nand PHY Ver:1.01.001.0006 (c) 2013 Amlogic Inc.
- init bus_cycle=6, bus_timing=7, system=5.0ns
- reset failed
- get_chip_type and ret:fffffffe
- get_chip_type and ret:fffffffe
- chip detect failed and ret:fffffffe
- nandphy_init failed and ret=0xfffffff1
- MMC: aml_priv->desc_buf = 0x0000000073ecc6b0
- aml_priv->desc_buf = 0x0000000073ece9d0
- SDIO Port B: 0, SDIO Port C: 1
- emmc/sd response timeout, cmd8, status=0x1ff2800
- emmc/sd response timeout, cmd55, status=0x1ff2800
- [mmc_startup] mmc refix success
- [mmc_init] mmc init success
- mmc read lba=0x14000, blocks=0x400
- Amlogic multi-dtb tool
- Single dtb detected
- start dts,buffer=0000000073ed1270,dt_addr=0000000073ed1270
- parts: 11
- 00: logo 0000000002000000 1
- 01: recovery 0000000002000000 1
- 02: rsv 0000000000800000 1
- 03: tee 0000000000800000 1
- 04: crypt 0000000002000000 1
- 05: misc 0000000002000000 1
- 06: instaboot 0000000020000000 1
- 07: boot 0000000002000000 1
- 08: system 0000000040000000 1
- 09: cache 0000000020000000 2
- 10: data ffffffffffffffff 4
- get_dtb_struct: Get emmc dtb OK!
- overide_emmc_partition_table: overide cache
- [mmc_get_partition_table] skip partition cache.
- Partition table get from SPL is :
- name offset size flag
- ===================================================================================
- 0: bootloader 0 400000 0
- 1: reserved 2400000 4000000 0
- 2: cache 6c00000 20000000 2
- 3: env 27400000 800000 0
- 4: logo 28400000 2000000 1
- 5: recovery 2ac00000 2000000 1
- 6: rsv 2d400000 800000 1
- 7: tee 2e400000 800000 1
- 8: crypt 2f400000 2000000 1
- 9: misc 31c00000 2000000 1
- 10: instaboot 34400000 20000000 1
- 11: boot 54c00000 2000000 1
- 12: system 57400000 40000000 1
- 13: data 97c00000 13a400000 4
- mmc read lba=0x12000, blocks=0x2
- mmc read lba=0x12002, blocks=0x2
- mmc_read_partition_tbl: mmc read partition OK!
- eMMC/TSD partition table have been checked OK!
- mmc env offset: 0x27400000
- In: serial
- Out: serial
- Err: serial
- reboot_mode=watchdog_reboot
- hpd_state=1
- [1080p60hz] is invalid for cvbs.
- set hdmitx VIC = 16
- config HPLL = 2970
- HPLL: 0xc000027b
- config HPLL done
- j = 4 vid_clk_div = 1
- hdmitx phy setting done
- hdmitx: set enc for VIC: 16
- enc_vpu_bridge_reset[1183]
- rx version is 1.4 or below div=10
- [store]To run cmd[emmc dtb_read 0x1000000 0x40000]
- read emmc dtb
- Amlogic multi-dtb tool
- Single dtb detected
- Net: dwmac.c9410000
- wipe_data=successful
- wipe_cache=successful
- upgrade_step=2
- [OSD]load fb addr from dts
- [OSD]failed to get fb addr for logo
- [OSD]use default fb_addr parameters
- [OSD]fb_addr for logo: 0x3d800000
- [OSD]load fb addr from dts
- [OSD]failed to get fb addr for logo
- [OSD]use default fb_addr parameters
- [OSD]fb_addr for logo: 0x3d800000
- [CANVAS]addr=0x3d800000 width=3840, height=2160
- amlkey_init() enter!
- [EFUSE_MSG]keynum is 4
- [KM]Error:f[key_manage_query_size]L507:key[usid] not programed yet
- [KM]Error:f[key_manage_query_size]L507:key[mac] not programed yet
- [KM]Error:f[key_manage_query_size]L507:key[deviceid] not programed yet
- gpio: pin GPIOAO_2 (gpio 102) value is 1
- Hit Enter or space or Ctrl+C key to stop autoboot -- : 0
- gxl_p212_v1#
Add Comment
Please, Sign In to add comment
