U-Boot 2018.03-armada-18.09.1-00241-g8fe4031

BootROM - 2.03
Starting CP-0 IOROM 1.07
Booting from SD 0 (0x29)
SD - wait_for_sd_interrupt: Error interrupt -  00008000
SD - wait_for_sd_interrupt: Error interrupt status 00000003
SD - sd_get_cmd_response: Get command response failed.

SD - sd_init: Failed - ret = 00000081
Error: Failed initializing interface
Error: Failed boot attempt 01. error = 0x0C1

BootROM - 2.03
Starting CP-0 IOROM 1.07
Booting from SD 0 (0x29)
SD - wait_for_sd_interrupt: Error interrupt -  00008000
SD - wait_for_sd_interrupt: Error interrupt status 00000003
SD - sd_get_cmd_response: Get command response failed.

SD - sd_init: Failed - ret = 00000081
Error: Failed initializing interface
Found valid image at boot postion 0x002
lNOTICE:  Starting binary extension
NOTICE:  SVC: SW Revision 0x0. SVC is not supported
mv_ddr: mv_ddr-armada-18.09.2-g99d7725 (Aug 29 2018 - 18:28:22)
mv_ddr: completed successfully
NOTICE:  Cold boot
NOTICE:  Booting Trusted Firmware
NOTICE:  BL1: v1.5(release):v1.5-221-g41c0feb (Marvell-armada-18.09.4)
NOTICE:  BL1: Built : 18:28:31, Aug 29 2018
NOTICE:  BL1: Booting BL2
NOTICE:  BL2: v1.5(release):v1.5-221-g41c0feb (Marvell-armada-18.09.4)
NOTICE:  BL2: Built : 18:28:35, Aug 29 2018
BL2: Initiating SCP_BL2 transfer to SCP
NOTICE:  SCP_BL2 contains 5 concatenated images
NOTICE:  Skipping MSS CP3 related image
NOTICE:  Skipping MSS CP2 related image
NOTICE:  Load image to CP1 MSS AP0
NOTICE:  Loading MSS image from addr. 0x4026734 Size 0x1b78 to MSS at 0xf4280000
NOTICE:  Done
NOTICE:  Load image to CP0 MSS AP0
NOTICE:  Loading MSS image from addr. 0x40282ac Size 0x1b78 to MSS at 0xf2280000
NOTICE:  Done
NOTICE:  Load image to AP0 MSS
NOTICE:  Loading MSS image from addr. 0x4029e24 Size 0x52a4 to MSS at 0xf0580000
NOTICE:  Done
NOTICE:  SCP Image doesn't contain PM firmware
NOTICE:  BL1: Booting BL31
lNOTICE:  MSS PM is not supported in this build
NOTICE:  BL31: v1.5(release):v1.5-221-g41c0feb (Marvell-armada-18.09.4)
NOTICE:  BL31: Built : 18:28:42, Aug 29 2018


U-Boot 2018.03-armada-18.09.1-00241-g8fe4031 (Aug 29 2018 - 18:27:21 +0300), Build: ga-18.09.4

Model: Marvell Armada 8040 MACCHIATOBin
SoC: Armada8040-A2; AP806-A1; 2xCP110-A2
Clock:  CPU     2000 [MHz]
        DDR     1200 [MHz]
        FABRIC  1200 [MHz]
        MSS     200  [MHz]
LLC Enabled (Exclusive Mode)
DRAM:  16 GiB
Comphy chip #0:
Comphy-0: PEX0
Comphy-1: PEX0
Comphy-2: PEX0
Comphy-3: PEX0
Comphy-4: SFI0          10.3125 Gbps
Comphy-5: SATA1
Comphy chip #1:
Comphy-0: SGMII1        1.25 Gbps
Comphy-1: SATA0
Comphy-2: USB3_HOST0
Comphy-3: SATA1
Comphy-4: SFI0          10.3125 Gbps
Comphy-5: SGMII2        3.125 Gbps
UTMI PHY 0 initialized to USB Host0
SATA link 0 timeout.
SATA link 1 timeout.
AHCI 0001.0000 32 slots 2 ports 6 Gbps 0x3 impl SATA mode
flags: 64bit ncq led only pmp fbss pio slum part sxs
PCIE-0: Link down
MMC:   sdhci@6e0000: 0, sdhci@780000: 1
Loading Environment from SPI Flash... Bus spi@700680 CS0 configured for direct access 00000000f9000000:0x1000000
SF: Detected w25q32bv with page size 256 Bytes, erase size 4 KiB, total 4 MiB
OK
Model: Marvell Armada 8040 MACCHIATOBin
Net:   eth0: mvpp2-0, eth1: mvpp2-3, eth2: mvpp2-4 [PRIME], eth3: mvpp2-5
Hit any key to stop autoboot:  0
switch to partitions #0, OK
mmc0(part 0) is current device
"Synchronous Abort" handler, esr 0x96000046

        Attempt to access RT service or TEE region (addr: 0x5000000, el2)
        Do not use address range 0x4000000-0x5400000

elr: 00000000000295c8 lr : 0000000000029584 (reloc)
elr: 000000007ff665c8 lr : 000000007ff66584
x0 : 0000000000000000 x1 : 0000000091005a4d
x2 : 00000000000f4203 x3 : 0000000005000000
x4 : 000000000000000d x5 : 000000000000000d
x6 : 000000007ffbf658 x7 : 0000000000000000
x8 : 000000007ffbf658 x9 : 0000000000000008
x10: 000000007f7b9b20 x11: 0000000000000001
x12: 000000007f7b9b20 x13: 00000000005d97c8
x14: 000000007f726f9c x15: 0000000000000002
x16: 000000007ffbc08d x17: 000000007ffbc08d
x18: 000000007f72cdd0 x19: 000000007f731f40
x20: 0000000000000020 x21: 000000007f7262c8
x22: 0000000000000001 x23: 0000000000000000
x24: 0000000000000000 x25: 0000000000000030
x26: 00000000000f4203 x27: 000000007ffb4000
x28: 0000000000000009 x29: 000000007f726200

Resetting CPU ...

resetting ...