bluetooth

int motorPin1 = 8;
int motorPin2 = 10;
int enablePin = 5;
int state;
int flag=0;        //makes sure that the serial only prints once the state

void setup() {
    // sets the pins as outputs:
    pinMode(motorPin1, OUTPUT);
    pinMode(motorPin2, OUTPUT);
    pinMode(enablePin, OUTPUT);
    // sets enablePin high so that motor can turn on:
    digitalWrite(enablePin, HIGH);
    // initialize serial communication at 9600 bits per second:
    Serial.begin(9600);
}

void loop() {
    //if some date is sent, reads it and saves in state
    if(Serial.available() > 0){
      state = Serial.read();
      flag=0;
    }
    // if the state is '0' the DC motor will turn off
    if (state == '0') {
        digitalWrite(motorPin1, LOW);
        digitalWrite(motorPin2, LOW);
        if(flag == 0){
          Serial.println("Motor: off");
          flag=1;
        }
    }
    // if the state is '1' the motor will turn right
    else if (state == '1') {
        digitalWrite(motorPin1, LOW);
        digitalWrite(motorPin2, HIGH);
        if(flag == 0){
          Serial.println("Motor: right");
          flag=1;
        }
    }
    // if the state is '2' the motor will turn left
    else if (state == '2') {
        digitalWrite(motorPin1, HIGH);
        digitalWrite(motorPin2, LOW);
        if(flag == 0){
          Serial.println("Motor: left");
          flag=1;
        }
    }

    else if (state == '3') {
      digitalWrite(motorPin1, HIGH);
      digitalWrite(motorPin2, HIGH);
      if(flag == 0){
        Serial.println("Motor: both");
        flag=1;
      }
    }
}