JLink Output

JLinkExe -device CORTEX-A5 -if JTAG -speed 40000 -jtagconf -1,-1 -autoconnect 1
SEGGER J-Link Commander V7.56b (Compiled Oct 18 2021 16:35:20)
DLL version V7.56b, compiled Oct 18 2021 16:35:03

Connecting to J-Link via USB...O.K.
Firmware: J-Link V10 compiled Sep 24 2021 16:39:44
Hardware version: V10.10
S/N: 50123621
License(s): GDB
VTref=1.797V
Device "CORTEX-A5" selected.


Connecting to target via JTAG
TotalIRLen = 15, IRPrint = 0x0011
JTAG chain detection found 2 devices:
 #0 Id: 0x4BA00477, IRLen: 04, CoreSight JTAG-DP
 #1 Id: 0x707400E1, IRLen: 11, Unknown device
Could not power-up system power domain.
DPv0 detected
Scanning AP map to find all available APs
AP[3]: Stopped AP scan as end of AP map seems to be reached
AP[0]: AHB-AP (IDR: 0x44770001)
AP[1]: APB-AP (IDR: 0x24770002)
AP[2]: JTAG-AP (IDR: 0x14760010)
Iterating through AP map to find APB-AP to use
AP[0]: Skipped. Not an APB-AP
AP[1]: APB-AP found
Invalid ROM table component ID 0x3F0F0F02 @ 0x30001EF0 (expected 0xB105100D). Trying again at alternative offset.
Invalid ROM table component ID 0x3F0F0F02 @ 0x60000FF0 (expected 0xB105100D). Trying again at alternative offset.
TotalIRLen = 15, IRPrint = 0x0011
JTAG chain detection found 2 devices:
 #0 Id: 0x4BA00477, IRLen: 04, CoreSight JTAG-DP
 #1 Id: 0x707400E1, IRLen: 11, Unknown device

****** Error: Cortex-A/R (connect): Could not determine address of core debug registers. Incorrect CoreSight ROM table in device?
TotalIRLen = 15, IRPrint = 0x0011
JTAG chain detection found 2 devices:
 #0 Id: 0x4BA00477, IRLen: 04, CoreSight JTAG-DP
 #1 Id: 0x707400E1, IRLen: 11, Unknown device
TotalIRLen = 15, IRPrint = 0x0011
JTAG chain detection found 2 devices:
 #0 Id: 0x4BA00477, IRLen: 04, CoreSight JTAG-DP
 #1 Id: 0x707400E1, IRLen: 11, Unknown device
Cannot connect to target.