AVAILABLE: blackmagic, jlink, mbed, stlink, stlink
CURRENT: upload_protocol = stlink
openocd -s C:\Users\Maxi\.platformio\packages\tool-openocd -f scripts/interface/stlink.cfg -c "transport select hla_swd" -f scripts/target/stm32f1x.cfg -c "reset_config none" -c "program {{.pioenvs\bluepill_f103c8\firmware.elf}}  verify reset; shutdown;"
GNU MCU Eclipse 32-bits Open On-Chip Debugger 0.10.0+dev-00392-gbe9ef0b0 (2018-01-12-10:20)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
hla_swd
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
adapter speed: 1000 kHz
adapter_nsrst_delay: 100
none separate
none separate
Info : Unable to match requested speed 1000 kHz, using 950 kHz
Info : Unable to match requested speed 1000 kHz, using 950 kHz
Info : clock speed 950 kHz
Info : STLINK v2 JTAG v17 API v2 SWIM v4 VID 0x0483 PID 0x3748
Info : using stlink api v2
Info : Target voltage: 3.253616
Error: init mode failed (unable to connect to the target)
in procedure 'program'
in procedure 'init' called at file "embedded:startup.tcl", line 495
in procedure 'ocd_bouncer'
** OpenOCD init failed **
shutdown command invoked

*** [upload] Error 1
 [ERROR] Took 1.79 seconds