U-Boot 2011.09-rc1-00003-ge89ab14-dirty (Jan 03 2014 - 12:57:33) Allwinner Technology

[      0.141]version: 1.1.0
[      0.144]pmbus:   ready
[      0.249]PMU: AXP209
[      0.252]PMU: AXP20x found
[      0.255]PMU: bat ratio = 100
[      0.258]after set, dcdc2 =1400mv
[      0.262]PMU: dcdc2 1400
[      0.264]PMU: pll1 912 Mhz
boot_clock = 912
dcdc2_vol = 1400
[      0.272]after set, dcdc2 =1400mv
dcdc3_vol = 1250
ldo2_vol = 3000
ldo3_vol = 2800
ldo4_vol = 2800
power_start = 0
storage_type = -1
usb_recovery = 1
find power_sply to end
fel key old mode
run key detect
no key found
no key input
dram_para_set start
dram_para_set end
[      0.308]DRAM:  1 GiB
relocation Offset is: 35b23000
donn't initialize ther user_gpio (main_key:boot_init_gpio)
DRV_DISP_Init: opened
[      0.522]boot_disp.output_type=4
[      0.526]boot_disp.output_mode=4
[      0.529]boot_disp.auto_hpd=1
workmode = 0
[      1.833]NAND: NAND_UbootInit
NB1 : enter NAND_LogicInit
nand : get id_number_ctl from script, 3
not burn nand partition table!
NB1 : nand_info_init fail
[      4.891]nand init fail
set to recovery
try sprite_led_gpio config
sprite_led_gpio start
sunxi sprite begin
screen_width = 800
screen_height = 480
bar x1: 200 y1: 200
bar x2: 600 y2: 280
read mbr failed
sprite update error: no data part found
read mbr failed
sprite update error: read image start error
sprite update error: current card sprite failed
now hold the machine
fail to find part named env
Using default environment

In:    serial
Out:   serial
Err:   serial
--------fastboot partitions--------
mbr not exist
base bootcmd=run setargs_nand boot_normal
bootcmd set setargs_nand
key 0
recovery key high 6, low 4
cant find fstbt value
no misc partition is found
to be run cmd=run setargs_nand boot_normal
the part isn't exist
WORK_MODE_BOOT
WORK_MODE_BOOT
[      4.985]Hit any key to stop autoboot:  0
cant find part named boot
sunxi_flash - sunxi_flash sub-system

Usage:
sunxi_flash read command parmeters :
parmeters 0 : addr to load(hex only)
parmeters 1 : the name of the part to be load
[parmeters 2] : the number of bytes to be load(hex only)
if [parmeters 2] not exist, the number of bytes to be load is the size of the part indecated on partemeter 1
boota: bad boot image magic, maybe not a boot.img?