Sharpyuk

U-Boot SPL 2011.09-00000-gf63b270-dirty (Nov 14 2011 - 10:37:14)
Texas Instruments Revision detection unimplemented
No AC power, disabling frequency switch
OMAP SD/MMC: 0
reading u-boot.img
reading u-boot.img


U-Boot 2011.09-00000-gf63b270-dirty (Nov 14 2011 - 10:37:14)

I2C:   ready
DRAM:  256 MiB
No daughter card present
NAND:  HW ECC Hamming Code selected
No NAND device found!!!
0 MiB
MMC:   OMAP SD/MMC: 0
*** Warning - readenv() failed, using default environment

Net:   cpsw
Hit any key to stop autoboot:  0
SD/MMC found on device 0
reading uEnv.txt

33 bytes read
Loaded environment from uEnv.txt
Importing environment from mmc ...
reading uImage

3031456 bytes read
## Booting kernel from Legacy Image at 80007fc0 ...
   Image Name:   Angstrom/3.1/beaglebone
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    3031392 Bytes = 2.9 MiB
   Load Address: 80008000
   Entry Point:  80008000
   Verifying Checksum ... OK
   XIP Kernel Image ... OK
OK

Starting kernel ...

Uncompressing Linux... done, booting the kernel.
[    0.067577] omap_l3_smx omap_l3_smx.0: couldn't find resource
[    0.244317] _omap_mux_get_by_name: Could not find signal leds-gpio
[    0.313787] omap2_set_init_voltage: unable to get clk dpll1_ck
[    0.319943] omap2_set_init_voltage: unable to set vdd_mpu_iva
[    0.326083] omap2_set_init_voltage: unable to get clk l3_ick
[    0.332084] omap2_set_init_voltage: unable to set vdd_core