U-Boot SPL 2013.10-00015-g0880266 (Nov 08 2013 - 16:10:03)
reading u-boot.img
reading u-boot.img


U-Boot 2013.10-00015-g0880266 (Nov 08 2013 - 16:10:03)

OMAP36XX/37XX-GP ES1.2, CPU-OPP2, L3-200MHz, Max CPU Clock 1 Ghz
OMAP3 Beagle board + LPDDR/NAND
I2C:   ready
DRAM:  512 MiB
NAND:  0 MiB
MMC:   OMAP SD/MMC: 0
*** Warning - readenv() failed, using default environment

In:    serial
Out:   serial
Err:   serial
Beagle xM Rev C
No EEPROM on expansion board
No EEPROM on expansion board
Die ID #346800229ff80000016830c41701000e
i2c_read (addr phase): pads on bus 0 probably not configured (status=0x10)
i2c_write: pads on bus 0 probably not configured (status=0x10)
i2c_read (addr phase): pads on bus 0 probably not configured (status=0x10)
i2c_write: pads on bus 0 probably not configured (status=0x10)
Net:   usb_ether
Hit any key to stop autoboot:  0
i2c_write: pads on bus 0 probably not configured (status=0x10)
Could not write vsel to reg 85 (2)
mmc0 is current device
i2c_write: pads on bus 0 probably not configured (status=0x10)
Could not write vsel to reg 85 (2)
gpio: pin 173 (gpio 173) value is 0
gpio: pin 4 (gpio 4) value is 0
SD/MMC found on device 0
reading uEnv.txt
1174 bytes read in 3 ms (381.8 KiB/s)
Loaded environment from uEnv.txt
Importing environment from mmc ...
Checking if uenvcmd is set ...
Running uenvcmd ...

Installer for [raring-armhf] is using the Video Interface
Use [--serial-mode] to force Installing over the Serial Interface

reading zImage.net
3422232 bytes read in 223 ms (14.6 MiB/s)
reading initrd.net
22356499 bytes read in 1366 ms (15.6 MiB/s)
Kernel image @ 0x80300000 [ 0x000000 - 0x343818 ]

Starting kernel ...

Uncompressing Linux...