thank you very much for your fantastic guide and support.

hello,

I have tried the steps, i am failing t mounting. i have used starup script, as per op plus others but i dont know where i am wrong. plz help guys.

below are the logs, which op specified. i am using 40gb hdd part one ext3 1gb, part 2 ext3 - rest.



dmesg
[CODE]root@DD-WRT:~# dmesg
<5>Linux version 2.6.23.17 (root@dd-wrt) (gcc version 4.5.2 (Linaro GCC 4.5-2011.02-0) ) #7096 Thu May 12 14:28:33 CEST 2011
<4>
<4> The CPU frequency set to 384 MHz
<6>64M RAM Detected!
<4>CPU revision is: 0001964c
<4>Determined physical RAM map:
<4> memory: 04000000 @ 00000000 (usable)
<7>On node 0 totalpages: 16384
<7>  Normal zone: 128 pages used for memmap
<7>  Normal zone: 0 pages reserved
<7>  Normal zone: 16256 pages, LIFO batch:3
<7>  Movable zone: 0 pages used for memmap
<4>Built 1 zonelists in Zone order.  Total pages: 16256
<5>Kernel command line: console=ttyS1,57600n8 root=/dev/mtdblock4 rootfstype=squashfs noinitrd
<4>Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.
<4>Primary data cache 16kB, 4-way, linesize 32 bytes.
<6>Synthesized TLB refill handler (20 instructions).
<6>Synthesized TLB load handler fastpath (32 instructions).
<6>Synthesized TLB store handler fastpath (32 instructions).
<6>Synthesized TLB modify handler fastpath (31 instructions).
<6>Cache parity protection disabled
<4>cause = 10800000, status = 1100ff00
<4>PID hash table entries: 256 (order: 8, 1024 bytes)
<4>calculating r4koff... 003a9800(3840000)
<4>CPU frequency 384.00 MHz
<4>Using 192.000 MHz high precision timer.
<4>Console: colour dummy device 80x25
<6>console [ttyS1] enabled
<6>Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
<6>Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
<6>Memory: 61688k/65536k available (2296k kernel code, 3784k reserved, 396k data, 120k init, 0k highmem)
<7>Calibrating delay loop... 255.59 BogoMIPS (lpj=1277952)
<4>Mount-cache hash table entries: 512
<6>NET: Registered protocol family 16
<6>Generic PHY: Registered new driver
<5>SCSI subsystem initialized
<6>usbcore: registered new interface driver usbfs
<6>usbcore: registered new interface driver hub
<6>usbcore: registered new device driver usb
<6>NET: Registered protocol family 2
<6>Time: MIPS clocksource has been installed.
<6>IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
<6>TCP established hash table entries: 2048 (order: 2, 16384 bytes)
<6>TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
<6>TCP: Hash tables configured (established 2048 bind 2048)
<6>TCP reno registered
<4>Load Ralink DFS Timer Module
<6>devfs: 2004-01-31 Richard Gooch ([email protected])
<6>devfs: boot_options: 0x1
<6>squashfs: version 3.0 (2006/03/15) Phillip Lougher
<6>io scheduler noop registered
<6>io scheduler deadline registered (default)
<4>Ralink gpio driver initialized
<6>Serial: 8250/16550 driver $Revision: 1.3 $ 2 ports, IRQ sharing disabled
<6>serial8250: ttyS0 at I/O 0xb0000500 (irq = 37) is a 16550A
<6>serial8250: ttyS1 at I/O 0xb0000c00 (irq = 12) is a 16550A
<4>rt3052 access driver initialization.
<6>PPP generic driver version 2.4.2
<6>PPP Deflate Compression module registered
<6>PPP BSD Compression module registered
<6>MPPE/MPPC encryption/compression module registered
<6>NET: Registered protocol family 24
<6>PPPoL2TP kernel driver, V1.0
<6>tun: Universal TUN/TAP device driver, 1.6
<6>tun: (C) 1999-2004 Max Krasnyansky <[email protected]>
<5>ralink flash device: 0x1000000 at 0xbf000000
<6>Ralink SoC physically mapped flash: Found 1 x16 devices at 0x0 in 16-bit bank
<7>Ralink SoC physically mapped flash: Found an alias at 0x800000 for the chip at 0x0
<4> Amd/Fujitsu Extended Query Table at 0x0040
<5>number of CFI chips: 1
<5>cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
<0>
<4>found squashfs at 138000
<5>Creating 6 MTD partitions on "Ralink SoC physically mapped flash":
<5>0x00000000-0x00030000 : "uboot"
<5>0x00030000-0x00040000 : "uboot-config"
<5>0x00040000-0x00050000 : "factory-defaults"
<5>0x00050000-0x007f0000 : "linux"
<5>0x00138000-0x007f0000 : "rootfs"
<4>mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only
<5>0x007f0000-0x00800000 : "nvram"
<6>Initializing USB Mass Storage driver...
<6>usbcore: registered new interface driver usb-storage
<6>USB Mass Storage support registered.
<6>usbcore: registered new interface driver libusual
<6>usbcore: registered new interface driver usbserial
<6>drivers/usb/serial/usb-serial.c: USB Serial Driver core
<6>dwc_otg: version 2.72a 24-JUN-2008
<6>DWC_otg: Core Release: 2.66a
<6>DWC_otg: Periodic Transfer Interrupt Enhancement - disabled
<6>DWC_otg: Multiprocessor Interrupt Enhancement - disabled
<6>DWC_otg: Using DMA mode
<6>DWC_otg: Device using Buffer DMA mode
<6>dwc_otg lm0: DWC OTG Controller
<6>dwc_otg lm0: new USB bus registered, assigned bus number 1
<6>dwc_otg lm0: irq 18, io mem 0x00000000
<6>DWC_otg: Init: Port Power? op_state=1
<6>DWC_otg: Init: Power Port (0)
<6>usb usb1: configuration #1 chosen from 1 choice
<6>hub 1-0:1.0: USB hub found
<6>hub 1-0:1.0: 1 port detected
<6>Ralink APSoC Hardware Watchdog Timer
<4>u32 classifier
<4>    Actions configured
<4>Netfilter messages via NETLINK v0.30.
<4>nf_conntrack version 0.5.0 (1024 buckets, 4096 max)
<4>ctnetlink v0.93: registering with nfnetlink.
<6>IPv4 over IPv4 tunneling driver
<6>GRE over IPv4 tunneling driver
<6>ip_tables: (C) 2000-2006 Netfilter Core Team
<6>IPP2P v0.8.2 loading
<5>ClusterIP Version 0.8 loaded successfully
<6>TCP bic registered
<6>TCP cubic registered
<6>TCP westwood registered
<6>TCP highspeed registered
<6>TCP hybla registered
<6>TCP htcp registered
<6>TCP vegas registered
<6>TCP scalable registered
<6>NET: Registered protocol family 1
<6>NET: Registered protocol family 17
<4>Welcome to PF_RING 3.2.1
<4>(C) 2004-06 L.Deri <[email protected]>
<6>NET: Registered protocol family 27
<4>PF_RING: bucket length    128 bytes
<4>PF_RING: ring slots       4096
<4>PF_RING: sample rate      1 [1=no sampling]
<4>PF_RING: capture TX       No [RX only]
<4>PF_RING: transparent mode Yes
<4>PF_RING initialized correctly.
<4>PF_RING: registered /proc/net/pf_ring/
<6>802.1Q VLAN Support v1.8 Ben Greear <[email protected]>
<6>All bugs added by David S. Miller <[email protected]>
<4>MAC_ADRH -- : 0x00000000
<4>MAC_ADRL -- : 0x00000000
<4>
<4>eth2 mii.o query= phy_id:0, address:1 retval:7849
<4>Ralink APSoC Ethernet Driver Initilization. v2.0  256 rx/tx descriptors allocated, mtu = 1500!
<4>NAPI enable, weight = 0, Tx Ring = 256, Rx Ring = 256
<4>MAC_ADRH -- : 0x0000000c
<4>MAC_ADRL -- : 0x43414632
<0>decode /dev/mtdblock4
<4>VFS: Mounted root (squashfs filesystem) readonly.
<6>Mounted devfs on /dev
<6>Freeing unused kernel memory: 120k freed
<4>rt2860v2_ap: module license 'unspecified' taints kernel.
<4>
<4>phy_tx_ring = 0x03d74000, tx_ring = 0xa3d74000
<4>
<4>phy_rx_ring0 = 0x03d75000, rx_ring0 = 0xa3d75000
<4>RT305x_ESW: Link Status Changed
<4>CDMA_CSG_CFG = 81000007
<4>GDMA1_FWD_CFG = 710000
<6>usbcore: registered new interface driver usblp
<3>br0: Dropping NETIF_F_UFO since no NETIF_F_HW_CSUM feature.
<6>device br0 entered promiscuous mode
<6>device vlan1 entered promiscuous mode
<6>device eth2 entered promiscuous mode
<6>br0: port 1(vlan1) entering learning state
<6>device br0 left promiscuous mode
<6>device br0 entered promiscuous mode
<6>device br0 left promiscuous mode
<6>device br0 entered promiscuous mode
<4>RtmpOSNetDevDetach(): RtmpOSNetDeviceDetach(), dev->name=ra0!
<4>0x1300 = 00064380
<6>br0: topology change detected, propagating
<6>br0: port 1(vlan1) entering forwarding state
<4>0x1300 = 00064380
<6>device ra0 entered promiscuous mode
<6>br0: port 2(ra0) entering learning state
<6>br0: topology change detected, propagating
<6>br0: port 2(ra0) entering forwarding state
<6>device vlan2 entered promiscuous mode
<6>device vlan2 left promiscuous mode
<1>vlan_check_real_dev: ALREADY had VLAN registered
<6>etherip: Ethernet over IPv4 tunneling driver[/CODE]



lsmode
[CODE]root@DD-WRT:~# lsmod
Module                  Size  Used by
nf_nat_pptp             4096  0
nf_conntrack_pptp       4096  1 nf_nat_pptp
nf_nat_proto_gre        4096  1 nf_nat_pptp
nf_conntrack_proto_gre     4096  1 nf_conntrack_pptp
etherip                 8192  0
rt2860v2_ap           479232  1
usblp                   8192  0
scsi_wait_scan           480  0
root@DD-WRT:~# cd /dev/discs/disc0;ls -lrt
-sh: cd: can't cd to /dev/discs/disc0
root@DD-WRT:~# cd /dev/discs/disc0;ls -lrt
-sh: cd: can't cd to /dev/discs/disc0[/CODE]


mount
[CODE]root@DD-WRT:~# mount
rootfs on / type rootfs (rw)
/dev/root on / type squashfs (ro)
none on /dev type devfs (rw)
proc on /proc type proc (rw)
sysfs on /sys type sysfs (rw)
ramfs on /tmp type ramfs (rw)
devpts on /dev/pts type devpts (rw)
devpts on /proc/bus/usb type usbfs (rw)
root@DD-WRT:~#[/CODE]