[ 7615.301416]
[ 7615.301431]  rfpwrstate_check call ips_leave....
[ 7615.301454] ==>ips_leave cnts:1
[ 7615.301464] ===>  rtw_ips_pwr_up..............
[ 7615.301495] ===> ips_netdrv_open.........
[ 7615.307513]  ===> FirmwareDownload91C() fw:Rtl819XFwImageArray_UMC_B
[ 7615.307547] FirmwareDownload92C accquire FW from embedded image
[ 7615.307565] fw_ver=v80, fw_subver=0, sig=0x88c0
[ 7615.372631] fw download ok!
[ 7615.372660] Set RF Chip ID to RF_6052 and RF type to 1T1R.
[ 7615.851477] IQK:Start!!!
[ 7615.864857] Path A IQK Success!!
[ 7615.874977] Path A IQK Success!!
[ 7615.880650] IQK: final_candidate is 0
[ 7615.880681] IQK: RegE94=100 RegE9C=c RegEA4=fb RegEAC=6 RegEB4=0 RegEBC=0 RegEC4=0 RegECC=0
[ 7615.880693]  Path A IQ Calibration Success !
[ 7615.995866] pdmpriv->TxPowerTrackControl = 1
[ 7616.002867] MAC Address from REG_MACID = 00:d1:1c:1d:22:20
[ 7616.002904] rtl8192cu_hal_init in 700ms
[ 7616.002983] <===  rtw_ips_pwr_up.............. in 700ms
[ 7616.003228] ==> ips_leave.....LED(0x00028080)...
[ 7616.003256] set_mode = IW_MODE_INFRA
[ 7617.999573] ==>pwr_state_check_handler .fw_state(8)
[ 7617.999605] ==> rtw_ps_cmd  , enqueue CMD
[ 7617.999693] ==>rtw_ps_processor .fw_state(8)
[ 7617.999710] ==>ips_enter cnts:2
[ 7618.000016] ==>power_saving_ctrl_wk_hdl change rf to OFF...LED(0x00028000)....
[ 7618.000028]
[ 7618.000040] ===> rtw_ips_pwr_down...................
[ 7618.000483] ====> rtw_ips_dev_unload...
[ 7618.036709] usb_read_port_cancel
[ 7618.037008] usb_write_port_cancel
[ 7618.037130] ==> rtl8192cu_hal_deinit
[ 7618.037144] bkeepfwalive(0)
[ 7618.037153] card disble without HWSM...........
[ 7618.045124] <=== rtw_ips_pwr_down..................... in 40ms