Starting kernel ...

Booting Linux on physical CPU 0x0
Linux version 3.9.0-sk (user@user-virtual-machine) (gcc version 4.7.3 20130226 (prerelease) (crosstool-NG linaro-1.13.1-4.7-2013.03-20130313 - Linaro GCC 2013.03) ) #2 Wed Aug 14 15:55:14 MSK 2013
CPU: ARMv7 Processor [412fc085] revision 5 (ARMv7), cr=50c53c7d
CPU: PIPT / VIPT nonaliasing data cache, VIPT aliasing instruction cache
Machine: Freescale i.MX53 (Device Tree Support), model: i.mx53 starterkit
cma: CMA: reserved 128 MiB at 78000000
Memory policy: ECC disabled, Data cache writeback
CPU: All CPU(s) started in SVC mode.
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 65024
Kernel command line: console=ttymxc0,115200 root=/dev/nfs ip=dhcp nfsroot=192.168.0.45:/home/user/imx535/rootfs/dev_fs/nfs,v3,tcp video=mxcdi0fb:RGB666,IPOOL-640x480-TFT di0_primary
PID hash table entries: 1024 (order: 0, 4096 bytes)
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
__ex_table already sorted, skipping sort
Memory: 256MB = 256MB total
Memory: 122764k/122764k available, 139380k reserved, 0K highmem
Virtual kernel memory layout:
    vector  : 0xffff0000 - 0xffff1000   (   4 kB)
    fixmap  : 0xfff00000 - 0xfffe0000   ( 896 kB)
    vmalloc : 0x90800000 - 0xff000000   (1768 MB)
    lowmem  : 0x80000000 - 0x90000000   ( 256 MB)
    modules : 0x7f800000 - 0x80000000   (   8 MB)
      .text : 0x80008000 - 0x804d0980   (4899 kB)
      .init : 0x804d1000 - 0x804f4f74   ( 144 kB)
      .data : 0x804f6000 - 0x80533be0   ( 247 kB)
       .bss : 0x80533be0 - 0x8059146c   ( 375 kB)
SLUB: Genslabs=11, HWalign=64, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
NR_IRQS:16 nr_irqs:16 16
TrustZone Interrupt Controller (TZIC) initialized
sched_clock: 32 bits at 50MHz, resolution 20ns, wraps every 85899ms
CPU identified as i.MX53, silicon rev 2.1
Console: colour dummy device 80x30
Calibrating delay loop... 795.44 BogoMIPS (lpj=3977216)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
Setting up static identity map for 0x80315938 - 0x80315984
devtmpfs: initialized
pinctrl core: initialized pinctrl subsystem
regulator-dummy: no parameters
NET: Registered protocol family 16
DMA: preallocated 256 KiB pool for atomic coherent allocations
syscon 53fa8000.iomuxc-gpr: syscon regmap start 0x53fa8000 end 0x53fa800b registered
imx53-pinctrl 53fa8000.iomuxc: initialized IMX pinctrl driver
bio: create slab <bio-0> at 0
reg_vpu: no parameters
3P3V: 3300 mV
vbus-supply: 5000 mV
vbus-supply: 5000 mV
vbus-supply: Failed to create debugfs directory
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
usbphy.4 supply vcc not found, using dummy regulator
usbphy.4 supply reset not found, using dummy regulator
usbphy.5 supply vcc not found, using dummy regulator
usbphy.5 supply reset not found, using dummy regulator
i2c i2c-0: IMX I2C adapter registered
Linux video capture interface: v2.00
pps_core: LinuxPPS API ver. 1 registered
pps_core: Software ver. 5.3.6 - Copyright 2005-2007 Rodolfo Giometti <giometti@linux.it>
PTP clock support registered
Advanced Linux Sound Architecture Driver Initialized.
Switching to clocksource mxc_timer1
NET: Registered protocol family 2
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP: reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
RPC: Registered named UNIX socket transport module.
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
RPC: Registered tcp NFSv4.1 backchannel transport module.
NFS: Registering the id_resolver key type
Key type id_resolver registered
Key type id_legacy registered
msgmni has been set to 495
Block layer SCSI generic (bsg) driver version 0.4 loaded (major 250)
io scheduler noop registered
io scheduler deadline registered
io scheduler cfq registered (default)
imx-sdma 63fb0000.sdma: initialized
Serial: IMX driver
53fbc000.serial: ttymxc0 at MMIO 0x53fbc000 (irq = 47) is a IMX
imx-sdma 63fb0000.sdma: loaded firmware 1.1
console [ttymxc0] enabled
[drm] Initialized drm 1.1.0 20060810
brd: module loaded
loop: module loaded
imx-ahci 10000000.sata: AHCI 0001.0100 32 slots 1 ports 3 Gbps 0x1 impl platform mode
imx-ahci 10000000.sata: flags: ncq sntf pm led clo only pmp pio slum part ccc
scsi0 : ahci_platform
ata1: SATA max UDMA/133 mmio [mem 0x10000000-0x10003fff] port 0x100 irq 44
NAND device: Manufacturer ID: 0xec, Chip ID: 0xda (Samsung NAND 256MiB 3,3V 8-bit), 256MiB, page size: 2048, OOB size: 64
Scanning device for bad blocks
ata1: SATA link down (SStatus 0 SControl 300)
Bad eraseblock 2032 at 0x00000fe00000
7 ofpart partitions found on MTD device mxc_nand
Creating 7 MTD partitions on "mxc_nand":
0x000000000000-0x000000100000 : "bootloader"
0x000000100000-0x000000180000 : "environment"
0x000000180000-0x000000200000 : "redundant-environment"
0x000000200000-0x000000600000 : "kernel"
0x000000600000-0x000000620000 : "fdt"
0x000000620000-0x000000e20000 : "ramdisk"
0x000000e20000-0x000010000000 : "filesystem"
spi_gpio spi_lvds0.6: master is unqueued, this is deprecated
CAN device driver interface
flexcan 53fc8000.can: device registered (reg_base=f57c8000, irq=98)
63fec000.ethernet supply phy not found, using dummy regulator
libphy: fec_enet_mii_bus: probed
ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
platform 53f80000.usb: Driver imx_usb requests probe deferral
platform 53f80200.usb: Driver imx_usb requests probe deferral
ads7846 spi32766.0: touchscreen, irq 230
input: ADS0 Touchscreen as /devices/spi_lvds0.6/spi_master/spi32766/spi32766.0/input/input0
rtc-ds1307 0-0068: rtc core: registered ds1338 as rtc0
rtc-ds1307 0-0068: 56 bytes nvram
rtc-pcf8563 0-0051: chip found, driver version 0.4.3
rtc-pcf8563 0-0051: pcf8563_get_datetime: read error
rtc-pcf8563 0-0051: rtc core: registered rtc-pcf8563 as rtc1
i2c /dev entries driver
coda 63ff4000.vpu: Initialized CODA7541.
coda 63ff4000.vpu: Firmware version: 13.4.29
usbcore: registered new interface driver uvcvideo
USB Video Class driver (1.1.1)
coda 63ff4000.vpu: codec registered as /dev/video0
imx2-wdt 53f98000.wdog: IMX2+ Watchdog Timer enabled. timeout=60s (nowayout=0)
cpuidle: using governor ladder
cpuidle: using governor menu
sdhci: Secure Digital Host Controller Interface driver
sdhci: Copyright(c) Pierre Ossman
sdhci-pltfm: SDHCI platform and OF driver helper
50004000.esdhc supply vqmmc not found, using dummy regulator
mmc0: SDHCI controller on 50004000.esdhc [50004000.esdhc] using ADMA
usbcore: registered new interface driver usbhid
usbhid: USB HID core driver
[drm] Supports vblank timestamp caching Rev 1 (10.10.2010).
[drm] No driver support for vblank timestamp query.
[drm] Initialized imx-drm 1.0.0 20120507 on minor 0
imx-ldb 53fa8008.ldb: no lcd enable gpio
imx-ipuv3 18000000.ipu: pinctrl_get_select_default failed with -19
resource: 0x1e030000 - 0x1e030fff
imx-ipuv3-camera imx-ipuv3-camera.2: MX5 Camera driver loaded
resource: 0x1e038000 - 0x1e038fff
imx-ipuv3-camera imx-ipuv3-camera.3: MX5 Camera driver loaded
imx-ipuv3-scaler imx-ipuv3-scaler.4: imx-ipuv3-scaleDevice registered as /dev/video1
imx-ipuv3-vdic imx-ipuv3-vdic.6: imx-ipuv3-vdicDevice registered as /dev/video3
imx-ipuv3 18000000.ipu: IPUv3M probed