U-Boot SPL 2013.01.01-00018-gff666a3 (Mar 18 2013 - 09:16:52)
OMAP SD/MMC: 0
reading u-boot.img
reading u-boot.img


U-Boot 2013.01.01-00018-gff666a3 (Mar 18 2013 - 09:16:52)

I2C:   ready
DRAM:  512 MiB
WARNING: Caches not enabled
NAND:  No NAND device found!!!
0 MiB
MMC:   OMAP SD/MMC: 0, OMAP SD/MMC: 1
*** Warning - readenv() failed, using default environment

musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, bulk combine, bulk split, HB-ISO Rx, HB-ISO Tx, SoftConn)
musb-hdrc: MHDRC RTL version 2.0
musb-hdrc: setup fifo_mode 4
musb-hdrc: 28/31 max ep, 16384/16384 memory
USB Peripheral mode controller at 47401000 using PIO, IRQ 0
musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, bulk combine, bulk split, HB-ISO Rx, HB-ISO Tx, SoftConn)
musb-hdrc: MHDRC RTL version 2.0
musb-hdrc: setup fifo_mode 4
musb-hdrc: 28/31 max ep, 16384/16384 memory
USB Host mode controller at 47401800 using PIO, IRQ 0
Net:   cpsw, usb_ether
Hit any key to stop autoboot:  0
Unknown command 'dfu_alt_info=boot' - try 'help'
Unknown command 'rootfs' - try 'help'
Unknown command 'MLO' - try 'help'
Unknown command 'u-boot.img' - try 'help'
Unknown command 'uEnv.txt' - try 'help'
mmc0 is current device
SD/MMC found on device 0
reading uEnv.txt
14 bytes read in 3 ms (3.9 KiB/s)
Loaded environment from uEnv.txt
Importing environment from mmc ...
4484848 bytes read in 834 ms (5.1 MiB/s)
22492 bytes read in 38 ms (577.1 KiB/s)
Booting from mmc ...
## Booting kernel from Legacy Image at 80200000 ...
   Image Name:   Angstrom/3.8.3/beaglebone
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    4484784 Bytes = 4.3 MiB
   Load Address: 80008000
   Entry Point:  80008000
   Verifying Checksum ... OK
## Flattened Device Tree blob at 80f80000
   Booting using the fdt blob at 0x80f80000
   Loading Kernel Image ... OK
OK
   Loading Device Tree to 9fe28000, end 9fe307db ... OK

Starting kernel ...

Uncompressing Linux... done, booting the kernel.
[    0.106343] pinctrl-single 44e10800.pinmux: prop pinctrl-0 index 0 invalid phandle
[    0.224197] omap2_mbox_probe: platform not supported
[    0.474381] tps65217-bl tps65217-bl: no platform data provided
[    0.558587] bone-capemgr bone_capemgr.8: slot #0: No cape found
[    0.595693] bone-capemgr bone_capemgr.8: slot #1: No cape found
[    0.632800] bone-capemgr bone_capemgr.8: slot #2: No cape found
[    0.669910] bone-capemgr bone_capemgr.8: slot #3: No cape found
[    0.754416] pinctrl-single 44e10800.pinmux: pin 44e1080c already requested by mmc.4; cannot claim for gpio-leds.7
[    0.765285] pinctrl-single 44e10800.pinmux: pin-3 (gpio-leds.7) status -22
[    0.772523] pinctrl-single 44e10800.pinmux: could not request pin 3 on device pinctrl-single
[    5.649036] libphy: PHY 4a101000.mdio:01 not found
[    5.654106] net eth0: phy 4a101000.mdio:01 not found on slave 1