ZetaRC12 Dmesg

[87193.419909] usb usb5: root hub lost power or was reset
[87193.419942] pci 0000:00:1e.0: setting latency timer to 64
[87193.419975] ata_piix 0000:00:1f.1: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[87193.419986] ata_piix 0000:00:1f.1: setting latency timer to 64
[87193.420070] ahci 0000:00:1f.2: setting latency timer to 64
[87193.421025] sd 2:0:0:0: [sda] Starting disk
[87193.422127] ata2: port disabled. ignoring.
[87193.540332] PM: restore of drv: dev:ep_00 complete after 119.396 msecs
[87193.540367] PM: restore of drv:hub dev:5-0:1.0 complete after 119.544 msecs
[87193.540415] PM: restore of drv: dev:ep_81 complete after 119.539 msecs
[87193.540510] PM: restore of drv: dev:ep_00 complete after 119.799 msecs
[87193.540526] PM: restore of drv:hub dev:2-0:1.0 complete after 120.213 msecs
[87193.540543] PM: restore of drv:hub dev:4-0:1.0 complete after 119.934 msecs
[87193.540567] PM: restore of drv: dev:ep_00 complete after 120.250 msecs
[87193.540585] PM: restore of drv: dev:ep_81 complete after 119.927 msecs
[87193.540673] PM: restore of drv: dev:ep_81 complete after 120.364 msecs
[87193.540700] PM: restore of drv:uvcvideo dev:2-2:1.0 complete after 118.883 msecs
[87193.540756] PM: restore of drv: dev:ep_00 complete after 118.785 msecs
[87193.540773] PM: restore of drv:uvcvideo dev:2-2:1.1 complete after 118.844 msecs
[87193.540839] PM: restore of drv: dev:ep_82 complete after 118.973 msecs
[87193.644479] PM: restore of drv:usb-storage dev:3-2:1.0 complete after 223.231 msecs
[87193.644552] PM: restore of drv: dev:ep_00 complete after 222.994 msecs
[87193.644593] PM: restore of drv:scsi dev:host8 complete after 223.298 msecs
[87193.644649] PM: restore of drv: dev:ep_83 complete after 223.145 msecs
[87193.644682] PM: restore of drv:scsi_host dev:host8 complete after 223.335 msecs
[87193.644718] PM: restore of drv:scsi dev:target8:0:0 complete after 223.109 msecs
[87193.644736] PM: restore of drv:hub dev:3-0:1.0 complete after 224.393 msecs
[87193.644777] PM: restore of drv: dev:ep_00 complete after 224.284 msecs
[87193.644793] PM: restore of drv:sd dev:8:0:0:0 complete after 223.120 msecs
[87193.644810] PM: restore of drv: dev:ep_81 complete after 223.410 msecs
[87193.644838] PM: restore of drv:scsi_device dev:8:0:0:0 complete after 223.131 msecs
[87193.644847] PM: restore of drv: dev:ep_02 complete after 223.393 msecs
[87193.644885] PM: restore of drv: dev:ep_81 complete after 224.453 msecs
[87193.740223] ata3: SATA link up 1.5 Gbps (SStatus 113 SControl 300)
[87193.740285] ata5: SATA link down (SStatus 0 SControl 300)
[87193.741121] ata3.00: ACPI cmd ef/10:03:00:00:00:a0 (SET FEATURES) filtered out
[87193.802570] ata3.00: ACPI cmd 00/00:00:00:00:00:a0 (NOP) rejected by device (Stat=0x51 Err=0x04)
[87193.802756] ata3.00: configured for UDMA/100
[87193.867069] PM: restore of drv:sd dev:2:0:0:0 complete after 446.042 msecs
[87193.867137] PM: restore of drv:scsi_device dev:2:0:0:0 complete after 446.006 msecs
[87194.060338] PM: restore of drv:battery dev:PNP0C0A:00 complete after 640.929 msecs
[87194.192645] PM: restore of devices complete after 773.658 msecs
[87194.192940] PM: Image restored successfully.
[87194.192945] Restarting tasks ...
[87194.193132] usb 2-2: USB disconnect, device number 3
[87194.216102] done.
[87194.216137] PM: Basic memory bitmaps freed
[87194.216153] video LNXVIDEO:00: Restoring backlight state
[87194.340116] usb 3-1: new full speed USB device number 4 using uhci_hcd
[87194.504930] scsi9 : usb-storage 3-1:1.0
[87194.505312] usb 3-2: USB disconnect, device number 3
[87195.526511] scsi 9:0:0:0: Direct-Access              RCA              1050 PQ: 0 ANSI: 0 CCS
[87195.657376] sd 9:0:0:0: Attached scsi generic sg1 type 0
[87195.662524] sd 9:0:0:0: [sdc] 7950336 512-byte logical blocks: (4.07 GB/3.79 GiB)
[87195.665508] sd 9:0:0:0: [sdc] Write Protect is off
[87195.665523] sd 9:0:0:0: [sdc] Mode Sense: 3b 00 00 00
[87195.668550] sd 9:0:0:0: [sdc] No Caching mode page present
[87195.668563] sd 9:0:0:0: [sdc] Assuming drive cache: write through
[87195.684504] sd 9:0:0:0: [sdc] No Caching mode page present
[87195.684518] sd 9:0:0:0: [sdc] Assuming drive cache: write through
[87195.691701]  sdc: sdc1
[87195.704502] sd 9:0:0:0: [sdc] No Caching mode page present
[87195.704516] sd 9:0:0:0: [sdc] Assuming drive cache: write through
[87195.704528] sd 9:0:0:0: [sdc] Attached SCSI removable disk
[87195.710953] [drm:drm_mode_getfb] *ERROR* invalid framebuffer id
[87200.095570] ehci_hcd 0000:00:1d.7: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[87200.095619] ehci_hcd 0000:00:1d.7: setting latency timer to 64
[87200.095628] ehci_hcd 0000:00:1d.7: EHCI Host Controller
[87200.095815] ehci_hcd 0000:00:1d.7: new USB bus registered, assigned bus number 1
[87200.095877] ehci_hcd 0000:00:1d.7: using broken periodic workaround
[87200.095901] ehci_hcd 0000:00:1d.7: debug port 1
[87200.099824] ehci_hcd 0000:00:1d.7: cache line size of 64 is not supported
[87200.100926] ehci_hcd 0000:00:1d.7: irq 16, io mem 0x56344400
[87200.116159] ehci_hcd 0000:00:1d.7: USB 2.0 started, EHCI 1.00
[87200.116698] hub 1-0:1.0: USB hub found
[87200.116719] hub 1-0:1.0: 8 ports detected
[87200.192136] usb 3-1: USB disconnect, device number 4
[87200.592095] usb 1-2: new high speed USB device number 2 using ehci_hcd
[87200.912848] uvcvideo: Found UVC 1.00 device Webcam (04f2:b084)
[87200.916822] input: Webcam as /devices/pci0000:00/0000:00:1d.7/usb1/1-2/1-2:1.0/input/input13
[87201.144160] usb 1-4: new high speed USB device number 4 using ehci_hcd
[87201.290001] scsi10 : usb-storage 1-4:1.0
[87201.528090] usb 3-1: new full speed USB device number 5 using uhci_hcd
[87201.666658] usb 3-1: not running at top speed; connect to a high speed hub
[87201.701044] scsi11 : usb-storage 3-1:1.0
[87202.296913] scsi 10:0:0:0: Direct-Access     Ext Hard  Disk                 PQ: 0 ANSI: 4
[87202.424829] sd 10:0:0:0: Attached scsi generic sg1 type 0
[87202.428649] sd 10:0:0:0: [sdb] 2930277168 512-byte logical blocks: (1.50 TB/1.36 TiB)
[87202.431150] sd 10:0:0:0: [sdb] Write Protect is off
[87202.431166] sd 10:0:0:0: [sdb] Mode Sense: 10 00 00 00
[87202.432005] sd 10:0:0:0: [sdb] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[87202.436491]  sdb: sdb1
[87202.441386] sd 10:0:0:0: [sdb] Attached SCSI disk
[87202.712724] scsi 11:0:0:0: Direct-Access              RCA              1050 PQ: 0 ANSI: 0 CCS
[87202.735811] sd 11:0:0:0: Attached scsi generic sg2 type 0
[87202.740793] sd 11:0:0:0: [sdc] 7950336 512-byte logical blocks: (4.07 GB/3.79 GiB)
[87202.746566] sd 11:0:0:0: [sdc] Write Protect is off
[87202.746580] sd 11:0:0:0: [sdc] Mode Sense: 3b 00 00 00
[87202.749715] sd 11:0:0:0: [sdc] No Caching mode page present
[87202.749730] sd 11:0:0:0: [sdc] Assuming drive cache: write through
[87202.765724] sd 11:0:0:0: [sdc] No Caching mode page present
[87202.765735] sd 11:0:0:0: [sdc] Assuming drive cache: write through
[87202.772829]  sdc: sdc1
[87202.786764] sd 11:0:0:0: [sdc] No Caching mode page present
[87202.786780] sd 11:0:0:0: [sdc] Assuming drive cache: write through
[87202.786792] sd 11:0:0:0: [sdc] Attached SCSI removable disk
[87207.844157] EXT4-fs (sda5): re-mounted. Opts: errors=remount-ro,commit=0
[87208.727870] atl1c 0000:03:00.0: irq 45 for MSI/MSI-X
[87208.789077] ADDRCONF(NETDEV_UP): eth0: link is not ready
[87208.832537] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[91116.939891] atl1c 0000:03:00.0: atl1c: eth0 NIC Link is Up<100 Mbps Full Duplex>
[91116.940541] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[91127.136037] eth0: no IPv6 routers present
[119864.124638] sd 10:0:0:0: [sdb] Synchronizing SCSI cache
[119866.273665] WARNING! power/level is deprecated; use power/control instead
[119866.354706] usb 1-4: USB disconnect, device number 4
[119868.428167] usb 3-1: USB disconnect, device number 5