[10849.958469] ata2: exception Emask 0x10 SAct 0x0 SErr 0x10202 action 0xe frozen
[10849.958617] ata2: irq_stat 0x00400000, PHY RDY changed
[10849.958714] ata2: SError: { RecovComm Persist PHYRdyChg }
[10849.958816] ata2: hard resetting link
[10850.682133] ata2: SATA link down (SStatus 0 SControl 300)
[10855.679626] ata2: hard resetting link
[10855.999476] ata2: SATA link down (SStatus 0 SControl 300)
[10855.999496] ata2: limiting SATA link speed to 1.5 Gbps
[10860.997000] ata2: hard resetting link
[10861.316854] ata2: SATA link down (SStatus 0 SControl 310)
[10861.316873] ata2.00: disabled
[10861.316907] ata2: EH complete
[10861.316931] ata2.00: detaching (SCSI 1:0:0:0)
[10861.330171] sd 1:0:0:0: [sdb] Stopping disk
[10861.330231] sd 1:0:0:0: [sdb] START_STOP FAILED
[10861.330234] sd 1:0:0:0: [sdb]
[10861.330237] Result: hostbyte=DID_BAD_TARGET driverbyte=DRIVER_OK
[10894.036275] ata1: exception Emask 0x10 SAct 0x0 SErr 0x10202 action 0xe frozen
[10894.036419] ata1: irq_stat 0x00400000, PHY RDY changed
[10894.036557] ata1: SError: { RecovComm Persist PHYRdyChg }
[10894.036661] ata1: hard resetting link
[10894.118867] ata2: exception Emask 0x10 SAct 0x0 SErr 0x40c0000 action 0xe frozen
[10894.119015] ata2: irq_stat 0x00000040, connection status changed
[10894.119126] ata2: SError: { CommWake 10B8B DevExch }
[10894.119226] ata2: hard resetting link
[10897.954797] ata1: SATA link up 3.0 Gbps (SStatus 123 SControl 300)
[10897.955540] ata1.00: failed to enable AA (error_mask=0x1)
[10897.956604] ata1.00: failed to enable AA (error_mask=0x1)
[10897.956725] ata1.00: configured for UDMA/100
[10897.956752] ata1: EH complete
[10904.135696] ata2: softreset failed (device not ready)
[10904.135803] ata2: hard resetting link
[10905.031257] ata2: SATA link up 3.0 Gbps (SStatus 123 SControl 300)
[10905.031924] ata2.00: ATA-9: WDC WD30EFRX-68EUZN0, 82.00A82, max UDMA/133
[10905.031935] ata2.00: 5860533168 sectors, multi 0: LBA48 NCQ (depth 31/32), AA
[10905.032633] ata2.00: configured for UDMA/133
[10905.032654] ata2: EH complete
[10905.032838] scsi 1:0:0:0: Direct-Access     ATA      WDC WD30EFRX-68E 0A82 PQ: 0 ANSI: 5
[10905.039508] sd 1:0:0:0: [sdb] 5860533168 512-byte logical blocks: (3.00 TB/2.72 TiB)
[10905.039521] sd 1:0:0:0: [sdb] 4096-byte physical blocks
[10905.039625] sd 1:0:0:0: [sdb] Write Protect is off
[10905.039632] sd 1:0:0:0: [sdb] Mode Sense: 00 3a 00 00
[10905.039676] sd 1:0:0:0: [sdb] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[10905.039691] sd 1:0:0:0: Attached scsi generic sg1 type 0
[10905.090482]  sdb: sdb1