View difference between Paste ID: b39wSLJb and iMebGNER

 // home_automation_lights.ino
 #include <SerialCommand.h>
 #include <RCSwitch.h>
 
 #define APP_SERIAL_DEBUG	// comment this when in production mode
 
 const unsigned int SERIAL_PORT_BAUDRATE = 9600;		// change this accordingly
 const byte RC_SWITCH_TX_PIN = 10;					// change this accordingly
 char* LIGHT_ON_CODE = "000000000001010100010001";	// change this accordingly
 char* LIGHT_OFF_CODE = "000000000001010100010001";	// change this accordingly
 
 SerialCommand sCmd(Serial);     // the SerialCommand object used for string parsing over serial port
 RCSwitch rcSwitch = RCSwitch();	// the RCSwitch object used for RF commands
 
 // this gets called when you send "LIGHT_ON" string on the serial port
 void lightOn() {
 	#ifdef APP_SERIAL_DEBUG
   	Serial.println(F("Sending LIGHT_ON command..."));
   	#endif
 
 	rcSwitch.send(LIGHT_ON_CODE);
 }
 
-	Serial.begin(SERIAL_PORT_BAUDRATE);
+
 void lightOff() {
 	#ifdef APP_SERIAL_DEBUG
-  	sCmd.addCommand(F("LIGHT_ON"), lightOn);          // Turns Light on
+  	Serial.println(F("Sending LIGHT_OFF command..."));
-  	sCmd.addCommand(F("LIGHT_OFF"), lightOff);         // Turns Light off
+  	#endif
 
   	rcSwitch.send(LIGHT_OFF_CODE);
 }
 
-  	// this is just for debugging - you can comment this out in production
+void noCmdMatched() {
 	Serial.println(F("Invalid command sent!"));
 }
 
 void setup() {
 	Serial.begin(SERIAL_PORT_BAUDRATE);	// set serial port communications baudrate
 
 	// Setup callbacks for SerialCommand commands
   	sCmd.addCommand(F("LIGHT_ON"), lightOn);        // handler/callback setup for turning light on
   	sCmd.addCommand(F("LIGHT_OFF"), lightOff);      // handler/callback setup for turning light off
   	sCmd.setDefaultHandler(noCmdMatched);			// handler/callback setup for unknown command
 
   	// Transmitter is connected to Arduino Pin RC_SWITCH_TX_PIN set up above
   	rcSwitch.enableTransmit(RC_SWITCH_TX_PIN);
 
   	#ifdef APP_SERIAL_DEBUG
   	Serial.println(F("System ready..."));
   	#endif
 }
 
 void loop() {
 	sCmd.readSerial();     // process serial commands
 }