U-Boot 2015.07-15072-g45cfc85 (Jan 28 2016 - 17:41:49 -0700), Build: jenkins-uboot_v2015.07-30

CPU:   Freescale i.MX6Q rev1.2 996 MHz (running at 792 MHz)
Reset cause: POR
Board: Nitrogen6X
I2C:   ready
DRAM:  1 GiB
MMC:   FSL_SDHC: 0, FSL_SDHC: 1
SF: Detected SST25VF016B with page size 256 Bytes, erase size 4 KiB, total 2 MiB
Display: hdmi:1280x720M@60 (1280x720)
In:    serial
Out:   serial
Err:   serial
Net:   Micrel ksz9021 at 6
FEC [PRIME], usb_ether
Error: usb_ether address not set.

Hit any key to stop autoboot:  0
AHCI 0001.0300 32 slots 1 ports 3 Gbps 0x1 impl SATA mode
flags: ncq stag pm led clo only pmp pio slum part
No port device detected!
** Bad device size - sata 0 **

SATA device 1: unknown device
** Bad device sata 1 **
switch to partitions #0, OK
mmc0 is current device
reading /6x_bootscript
3194 bytes read in 13 ms (239.3 KiB/s)
## Executing script at 10008000
reading uEnv.txt
** Unable to read file uEnv.txt **
reading /imx6q-nitrogen6x.dtb
38267 bytes read in 18 ms (2 MiB/s)
Setting bus to 1
Error writing the chip: -19
libfdt fdt_path_offset() returned FDT_ERR_BADPATH
libfdt fdt_path_offset() returned FDT_ERR_BADPATH
non-CEA modes allowed on HDMI, audio may be affected
libfdt fdt_path_offset() returned FDT_ERR_BADPATH
libfdt fdt_path_offset() returned FDT_ERR_BADPATH
reading /zImage
6963184 bytes read in 334 ms (19.9 MiB/s)
Kernel image @ 0x10800000 [ 0x000000 - 0x6a3ff0 ]
## Flattened Device Tree blob at 13000000
   Booting using the fdt blob at 0x13000000
   reserving fdt memory region: addr=13000000 size=a000
   Using Device Tree in place at 13000000, end 1300cfff

Starting kernel ...