[ 2026.537384] twl4030_usb twl4030_usb: HW_CONDITIONS 0x50/80; link 1
[ 9697.018707] kb_lock (GPIO 113) is now closed
[ 9697.192260] kb_lock (GPIO 113) is now open
[ 9699.244995] slide (GPIO 71) is now open
[ 9714.932617] wl1251: 151 tx blocks at 0x3b788, 35 rx blocks at 0x3a780
[ 9714.948242] wl1251: firmware booted (Rev 4.0.4.3.7)
[ 9715.112426] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 9715.878112] wl1251: down
[ 9718.338867] wl1251: 151 tx blocks at 0x3b788, 35 rx blocks at 0x3a780
[ 9718.354522] wl1251: firmware booted (Rev 4.0.4.3.7)
[ 9718.472137] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 9719.229675] wlan0: authenticate with AP 48:5b:39:e8:67:26
[ 9719.232147] wlan0: authenticated
[ 9719.232177] wlan0: associate with AP 48:5b:39:e8:67:26
[ 9719.235992] wlan0: RX AssocResp from 48:5b:39:e8:67:26 (capab=0x411 status=0 aid=2)
[ 9719.236022] wlan0: associated
[ 9719.354949] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[ 9720.075225] wlan0: roaming signal from driver, sending LOWSIGNAL
[ 9721.099456] wlan0: roaming signal from driver, sending HIGHSIGNAL
[ 9722.123901] wlan0: roaming signal from driver, sending LOWSIGNAL
[ 9729.862121] wlan0: no IPv6 routers present
[ 9731.851318] wlan0: roaming signal from driver, sending HIGHSIGNAL
[ 9774.869903] kb_lock (GPIO 113) is now closed
[ 9775.026123] kb_lock (GPIO 113) is now open