booting up post-login screen problems.

EXT4-fs (mmcblk0p2): couldn't mount as ext3 due to feature incompatibilities
EXT4-fs (mmcblk0p2): couldn't mount as ext2 due to feature incompatibilities
EXT4-fs (mmcblk0p2): mounted filesystem with ordered data mode. Opts: (null)
VFS: Mounted root (ext4 filesystem) on device 179:2.
devtmpfs: mounted
Freeing unused kernel memory: 312K (80b8b000 - 80bd9000)
usb 1-1: new full-speed USB device number 2 using ci_hdrc
hub 1-1:1.0: USB hub found
hub 1-1:1.0: 4 ports detected
init: plymouth-upstart-bridge main process (163) terminated with status 1
init: plymouth-upstart-bridge main process ended, respawning
init: plymouth-upstart-bridge main process (173) terminated with status 1
init: plymouth-upstart-bridge main process ended, respawning
init: plymouth-upstart-bridge main process (176) terminated with status 1
init: plymouth-upstart-bridge main process ended, respawning
init: plymouth-upstart-bridge main process (178) terminated with status 1
init: plymouth-upstart-bridge main process ended, respawning
init: plymouth-upstart-bridge main process (181) terminated with status 1
init: plymouth-upstart-bridge main process ended, respawning
init: ureadahead main process (166) terminated with status 5
usb 1-1.3: new low-speed USB device number 3 using ci_hdrc
init: mounted-proc main process (195) terminated with status 1
input: USB Optical Mouse as /devices/soc0/soc.1/2100000.aips-bus/2184000.usb/ci_hdrc.0/usb1/1-1/1-1.3/1-1.3:1.0/input/input2
hid-generic 0003:04CA:0061.0001: input: USB HID v1.11 Mouse [USB Optical Mouse] on usb-ci_hdrc.0-1.3/input0
usb 1-1.4: new low-speed USB device number 4 using ci_hdrc
input: Logitech Logitech USB Keyboard as /devices/soc0/soc.1/2100000.aips-bus/2184000.usb/ci_hdrc.0/usb1/1-1/1-1.4/1-1.4:1.0/input/input3
hid-generic 0003:046D:C315.0002: input: USB HID v1.10 Keyboard [Logitech Logitech USB Keyboard] on usb-ci_hdrc.0-1.4/input0
systemd-udevd[336]: starting version 204
fec 2188000.ethernet eth0: Freescale FEC PHY driver [Atheros 8035 ethernet] (mii_bus:phy_addr=2188000.ethernet:00, irq=-1)
IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
libphy: 2188000.ethernet:00 - Link is Up - 1000/Full
IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
init: failsafe main process (645) killed by TERM signal
init: alsa-restore main process (918) terminated with status 99
IPv6: ADDRCONF(NETDEV_UP): bond0: link is not ready
8021q: adding VLAN 0 to HW filter on device bond0
init: plymouth-upstart-bridge main process ended, respawning
$ df