OMAP3 beagleboard.org # nand erase.chip

NAND erase.chip: device 0 whole chip
Erasing at 0xffe0000 -- 100% complete.
OK
OMAP3 beagleboard.org # reset
resetting ...
�
�t�b�
$U
               @
 @
 @
D��`
 @
 @

U-Boot SPL 2013.04-rc2-00017-g5f62c5f (Apr 15 2013 - 11:15:20)
OMAP SD/MMC: 0
reading u-boot.img
reading u-boot.img


U-Boot 2013.04-rc2-00017-g5f62c5f (Apr 15 2013 - 11:15:20)

OMAP3530-GP ES2.1, CPU-OPP2, L3-165MHz, Max CPU Clock 600 mHz
OMAP3 Beagle board + LPDDR/NAND
I2C:   ready
DRAM:  128 MiB
NAND:  256 MiB
MMC:   OMAP SD/MMC: 0
*** Warning - bad CRC, using default environment

In:    serial
Out:   serial
Err:   serial
Beagle Rev Ax/Bx
Recognized Tincantools Zippy2 board (rev 1 ������������������������������������������������������������������������������������������)
No EEPROM on expansion board
Die ID #7f8400020000000004013ef10100c01d
musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, bulk combine, bulk split, HB-ISO Rx, HB-ISO Tx, SoftConn)
musb-hdrc: MHDRC RTL version 1.400
musb-hdrc: setup fifo_mode 4
musb-hdrc: 28/31 max ep, 16384/16384 memory
USB Peripheral mode controller at 480ab000 using PIO, IRQ 0
Net:   usb_ether
Hit any key to stop autoboot:  0
OMAP3 beagleboard.org # version

U-Boot 2013.04-rc2-00017-g5f62c5f (Apr 15 2013 - 11:15:20)
arm-linux-gnueabi-gcc (crosstool-NG linaro-1.13.1-2012.04-20120426 - Linaro GCC 2012.04) 4.7.1 20120402 (prerelease)
GNU ld (crosstool-NG linaro-1.13.1-2012.04-20120426 - Linaro GCC 2012.04) 2.22
OMAP3 beagleboard.org #