Advertisement
Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- random: Trying to read entropy from /dev/random
- Configuration file: /etc/hostapd/hostapd.conf
- nl80211: Could not add multicast membership for vendor events: -2 (No such
- file or directory)
- rfkill: initial event: idx=0 type=1 op=0 soft=0 hard=0
- nl80211: Supported cipher 00-0f-ac:1
- nl80211: Supported cipher 00-0f-ac:5
- nl80211: Supported cipher 00-0f-ac:2
- nl80211: Supported cipher 00-0f-ac:4
- nl80211: Using driver-based off-channel TX
- nl80211: interface wlan1 in phy phy0
- nl80211: Set mode ifindex 4 iftype 3 (AP)
- nl80211: Setup AP(wlan1) - device_ap_sme=0 use_monitor=0
- nl80211: Subscribe to mgmt frames with AP handle 0x14cc908
- nl80211: Register frame type=0xb0 (WLAN_FC_STYPE_AUTH) nl_handle=0x14cc908
- match=
- nl80211: Register frame type=0x0 (WLAN_FC_STYPE_ASSOC_REQ)
- nl_handle=0x14cc908 match=
- nl80211: Register frame type=0x20 (WLAN_FC_STYPE_REASSOC_REQ)
- nl_handle=0x14cc908 match=
- nl80211: Register frame type=0xa0 (WLAN_FC_STYPE_DISASSOC)
- nl_handle=0x14cc908 match=
- nl80211: Register frame type=0xc0 (WLAN_FC_STYPE_DEAUTH)
- nl_handle=0x14cc908 match=
- nl80211: Register frame type=0xd0 (WLAN_FC_STYPE_ACTION)
- nl_handle=0x14cc908 match=
- nl80211: Register frame type=0x40 (WLAN_FC_STYPE_PROBE_REQ)
- nl_handle=0x14cc908 match=
- nl80211: Add own interface ifindex 4
- nl80211: if_indices[16]: 4
- phy: phy0
- BSS count 1, BSSID mask 00:00:00:00:00:00 (0 bits)
- nl80211: Regulatory information - country=00
- nl80211: 2402-2472 @ 40 MHz 20 mBm
- nl80211: 2457-2482 @ 40 MHz 20 mBm (no IR)
- nl80211: 2474-2494 @ 20 MHz 20 mBm (no OFDM) (no IR)
- nl80211: 5170-5250 @ 160 MHz 20 mBm (no IR)
- nl80211: 5250-5330 @ 160 MHz 20 mBm (DFS) (no IR)
- nl80211: 5490-5730 @ 160 MHz 20 mBm (DFS) (no IR)
- nl80211: 5735-5835 @ 80 MHz 20 mBm (no IR)
- nl80211: 57240-63720 @ 2160 MHz 0 mBm
- nl80211: Added 802.11b mode based on 802.11g information
- Allowed channel: mode=1 chan=1 freq=2412 MHz max_tx_power=20 dBm
- Allowed channel: mode=1 chan=2 freq=2417 MHz max_tx_power=20 dBm
- Allowed channel: mode=1 chan=3 freq=2422 MHz max_tx_power=20 dBm
- Allowed channel: mode=1 chan=4 freq=2427 MHz max_tx_power=20 dBm
- Allowed channel: mode=1 chan=5 freq=2432 MHz max_tx_power=20 dBm
- Allowed channel: mode=1 chan=6 freq=2437 MHz max_tx_power=20 dBm
- Allowed channel: mode=1 chan=7 freq=2442 MHz max_tx_power=20 dBm
- Allowed channel: mode=1 chan=8 freq=2447 MHz max_tx_power=20 dBm
- Allowed channel: mode=1 chan=9 freq=2452 MHz max_tx_power=20 dBm
- Allowed channel: mode=1 chan=10 freq=2457 MHz max_tx_power=20 dBm
- Allowed channel: mode=1 chan=11 freq=2462 MHz max_tx_power=20 dBm
- Allowed channel: mode=0 chan=1 freq=2412 MHz max_tx_power=20 dBm
- Allowed channel: mode=0 chan=2 freq=2417 MHz max_tx_power=20 dBm
- Allowed channel: mode=0 chan=3 freq=2422 MHz max_tx_power=20 dBm
- Allowed channel: mode=0 chan=4 freq=2427 MHz max_tx_power=20 dBm
- Allowed channel: mode=0 chan=5 freq=2432 MHz max_tx_power=20 dBm
- Allowed channel: mode=0 chan=6 freq=2437 MHz max_tx_power=20 dBm
- Allowed channel: mode=0 chan=7 freq=2442 MHz max_tx_power=20 dBm
- Allowed channel: mode=0 chan=8 freq=2447 MHz max_tx_power=20 dBm
- Allowed channel: mode=0 chan=9 freq=2452 MHz max_tx_power=20 dBm
- Allowed channel: mode=0 chan=10 freq=2457 MHz max_tx_power=20 dBm
- Allowed channel: mode=0 chan=11 freq=2462 MHz max_tx_power=20 dBm
- Completing interface initialization
- Mode: IEEE 802.11g Channel: 1 Frequency: 2412 MHz
- DFS 0 channels required radar detection
- nl80211: Set freq 2412 (ht_enabled=0, vht_enabled=0, bandwidth=20 MHz,
- cf1=2412 MHz, cf2=0 MHz)
- RATE[0] rate=10 flags=0x1
- RATE[1] rate=20 flags=0x1
- RATE[2] rate=55 flags=0x1
- RATE[3] rate=110 flags=0x1
- RATE[4] rate=60 flags=0x0
- RATE[5] rate=90 flags=0x0
- RATE[6] rate=120 flags=0x0
- RATE[7] rate=180 flags=0x0
- RATE[8] rate=240 flags=0x0
- RATE[9] rate=360 flags=0x0
- RATE[10] rate=480 flags=0x0
- RATE[11] rate=540 flags=0x0
- hostapd_setup_bss(hapd=0x14cbf00 (wlan1), first=1)
- wlan1: Flushing old station entries
- nl80211: flush -> DEL_STATION wlan1 (all)
- wlan1: Deauthenticate all stations
- nl80211: send_mlme - da= ff:ff:ff:ff:ff:ff noack=0 freq=0 no_cck=0
- offchanok=0 wait_time=0 fc=0xc0 (WLAN_FC_STYPE_DEAUTH) nlmode=3
- nl80211: send_mlme -> send_frame
- nl80211: send_frame - Use bss->freq=2412
- nl80211: send_frame -> send_frame_cmd
- nl80211: CMD_FRAME freq=2412 wait=0 no_cck=0 no_ack=0 offchanok=0
- CMD_FRAME - hexdump(len=26): c0 00 00 00 ff ff ff ff ff ff 00 c1 41 07 07
- d0 00 c1 41 07 07 d0 00 00 02 00
- nl80211: Frame command failed: ret=-16 (Device or resource busy) (freq=2412
- wait=0)
- wpa_driver_nl80211_set_key: ifindex=4 (wlan1) alg=0 addr=(nil) key_idx=0
- set_tx=0 seq_len=0 key_len=0
- wpa_driver_nl80211_set_key: ifindex=4 (wlan1) alg=0 addr=(nil) key_idx=1
- set_tx=0 seq_len=0 key_len=0
- wpa_driver_nl80211_set_key: ifindex=4 (wlan1) alg=0 addr=(nil) key_idx=2
- set_tx=0 seq_len=0 key_len=0
- wpa_driver_nl80211_set_key: ifindex=4 (wlan1) alg=0 addr=(nil) key_idx=3
- set_tx=0 seq_len=0 key_len=0
- Using interface wlan1 with hwaddr 00:c1:41:07:07:d0 and ssid "FREE"
- nl80211: Set beacon (beacon_set=0)
- nl80211: Beacon head - hexdump(len=55): 80 00 00 00 ff ff ff ff ff ff 00 c1
- 41 07 07 d0 00 c1 41 07 07 d0 00 00 00 00 00 00 00 00 00 00 64 00 01 04 00
- 04 46 52 45 45 01 08 82 84 8b 96 0c 12 18 24 03 01 01
- nl80211: Beacon tail - hexdump(len=19): 2a 01 04 32 04 30 48 60 6c 7f 08 00
- 00 00 00 00 00 00 40
- nl80211: ifindex=4
- nl80211: beacon_int=100
- nl80211: dtim_period=2
- nl80211: ssid - hexdump_ascii(len=4):
- 46 52 45 45 FREE
- nl80211: hidden SSID not in use
- nl80211: privacy=0
- nl80211: auth_algs=0x3
- nl80211: wpa_version=0x0
- nl80211: key_mgmt_suites=0x2
- nl80211: pairwise_ciphers=0x1
- nl80211: group_cipher=0x1
- nl80211: beacon_ies - hexdump(len=10): 7f 08 00 00 00 00 00 00 00 40
- nl80211: proberesp_ies - hexdump(len=10): 7f 08 00 00 00 00 00 00 00 40
- nl80211: assocresp_ies - hexdump(len=10): 7f 08 00 00 00 00 00 00 00 40
- nl80211: Set wlan1 operstate 0->1 (UP)
- netlink: Operstate: ifindex=4 linkmode=-1 (no change), operstate=6
- (IF_OPER_UP)
- wlan1: interface state UNINITIALIZED->ENABLED
- wlan1: AP-ENABLED
- wlan1: Setup of interface done.
- ctrl_iface not configured!
- random: Got 20/20 bytes from /dev/random
- RTM_NEWLINK: ifi_index=4 ifname=wlan1 operstate=0 linkmode=0 ifi_family=0
- ifi_flags=0x1043 ([UP][RUNNING])
- RTM_NEWLINK: ifi_index=4 ifname=wlan1 operstate=2 linkmode=0 ifi_family=0
- ifi_flags=0x1003 ([UP])
- RTM_NEWLINK: ifi_index=4 ifname=wlan1 operstate=6 linkmode=0 ifi_family=0
- ifi_flags=0x11043 ([UP][RUNNING][LOWER_UP])
Advertisement
Add Comment
Please, Sign In to add comment
Advertisement