GRBL Settings 0.9i upgrade

GRBL Config settings after upgrade from 0.9g to 0.91

Grbl 0.9i ['$' for help]
['$H'|'$X' to unlock]
$$
$0=30 (step pulse, usec)
$1=255 (step idle delay, msec)
$2=0 (step port invert mask:00000000)
$3=7 (dir port invert mask:00000111)
$4=0 (step enable invert, bool)
$5=0 (limit pins invert, bool)
$6=0 (probe pin invert, bool)
$10=3 (status report mask:00000011)
$11=0.050 (junction deviation, mm)
$12=0.010 (arc tolerance, mm)
$13=1 (report inches, bool)
$20=0 (soft limits, bool)
$21=1 (hard limits, bool)
$22=1 (homing cycle, bool)
$23=3 (homing dir invert mask:00000011)
$24=25.000 (homing feed, mm/min)
$25=1000.000 (homing seek, mm/min)
$26=100 (homing debounce, msec)
$27=1.000 (homing pull-off, mm)
$100=40.020 (x, step/mm)
$101=40.020 (y, step/mm)
$102=320.000 (z, step/mm)
$110=2500.000 (x max rate, mm/min)
$111=2500.000 (y max rate, mm/min)
$112=500.000 (z max rate, mm/min)
$120=75.000 (x accel, mm/sec^2)
$121=75.000 (y accel, mm/sec^2)
$122=25.000 (z accel, mm/sec^2)
$130=288.000 (x max travel, mm)
$131=325.000 (y max travel, mm)
$132=0.000 (z max travel, mm)