samco@samco-desktop:~/7i80/utils/linux$ sudo ./mesaflash --device 7i80 --verboseboard name: 7I80HD-16
area 0: HostMot2
  RW, registers, 32bit [size=65536]
area 1: KSZ8851
  RW, registers, 16bit [size=256]
area 2: EtherEEP
  RW, EEPROM, 16bit [size=128], page size: 0x1, erase size: 0x1
area 3: FPGAFlsh
  RW, flash, 32bit [size=16777216], page size: 0x100, erase size: 0x10000
area 6: LBP16RW
  RW, memory, 16bit [size=16]
area 7: LBP16RO
  RO, memory, 16bit [size=16]
eth eeprom info:
  mac address: 00:60:1B:11:80:17
  ip address: 192.168.1.121
  board name: 7I80HD-16
  user leds: eth debug
FPGA flash eeprom info:
  flash id: 0x14 (size 16Mb)
lba16 status/control info:
  packets recived: all 188, UDP 2, bad 0
  packets sended: all 3, UDP 2, bad 0
  parse errors: 0, mem errors 0, write errors 0
  UDP time: 0
board info:
  board name: 7I80HD-16
  LBP16 version 2
  firmware version 13
  IP address jumpers at boot: fixed 192.168.1.121
firmware info:
  cookie: 55AACAFE
  name: HOSTMOT2
  IDROM version: 3
  Module 0: Watchdog, version 0 [instances=1]
  Module 1: IOPort, version 0 [instances=3]
  Module 2: Muxed Encoder, version 3 [instances=6]
  Module 3: Muxed Encoder Select, version 0 [instances=1]
  Module 4: PWMGen, version 0 [instances=6]
  Module 5: Smart Serial Interface, version 0 [instances=1]
  Module 6: LED, version 0 [instances=1]
samco@samco-desktop:~/7i80/utils/linux$