★ Eddie Halynn takes the wraps out from his bag, laying them on the ground, and cuts 3 pieces to roughly-
★ the correct size of each panel      ((Eddie Halynn))
★ Eddie Halynn takes some adhesive from his bag as well, coating the front tire panel with it
★ Eddie Halynn lines up the front tire wrap with the panel and sticks it, cutting any excess off of theside
★ he rubs the wrap from the inside out, removing any bubbles      ((Eddie Halynn))
★ the front tire would be finished      ((Eddie Halynn))
★ Eddie Halynn then takes the wrap cut for the main body, and preps it to be stuck
★ he applies the adhesive once again      ((Eddie Halynn))
★ Eddie Halynn places the wrap against the body, cutting any excess off
★ he would rub the wrap from the inside out, removing any bubbles      ((Eddie Halynn))
★ Eddie Halynn does another look to make sure all bubbles are gone and the edges are flush
★ the body would be done      ((Eddie Halynn))
★ Eddie Halynn repeats this same process for the rear panel, also rubbing any bubbles out and trimming
★ the bike would be wrapped      ((Eddie Halynn))
★ Eddie Halynn scores the paint off of the exaust, leaving it bare
★ he takes an airbrush and recolors the exaust dark red      ((Eddie Halynn))
★ the exaust would be recolored      ((Eddie Halynn))