Advertisement
Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- <6>[28555.491130] max17040_work : VCELL:4343mV, AVGVCELL:4332mV
- <6>[28555.491191] max17040_work : Raw SOC:9909%, SOC:100%
- <6>[28555.493266] max17040_work : CONFIG:0x1c85, RATE:0x4600
- <6>[28555.494304] max17040_work : STATUS:0xff01, temperature:29
- <6>[28555.510633] max17040 13-0036: 30d9h,32c6h,0000h,1100h,0000h,1c85h,ffffh,ffffh,ffffh,ff00h,4600h,057dh,ff01h,ffffh,
- <3>[28563.899767] init: untracked pid 14629 exited
- <6>[28573.836804] pm8921_enable_batt_therm: [pm8921] enable Vref_batt_therm
- <6>[28574.339047] pm8921_enable_batt_therm: [pm8921] disable Vref_batt_therm
- <6>[28574.339077] sec_bat_monitor_work: battery check is present (1 time )
- <6>[28574.343106] [battery] level(100), vcell(4340000), therm(299)
- <6>[28574.343137] [battery] cable_type(1), chg_status(1), health(1)
- <6>[28574.343198] [battery] timeout_chgstp(0), chg_enabled(1), rechg_status(0)
- <5>[28580.376831] mms_ts 3-0048: finger [0] down
- <6>[28580.377442] [TSP] DVFS On!
- <5>[28580.429998] mms_ts 3-0048: finger [0] up
- <4>[28580.513654] ## wifi_probe
- <4>[28580.513654] wifi_set_power = 1
- <6>[28580.513685] ------------------------------------------------
- <6>[28580.513685] ------------------------------------------------
- <6>[28580.513685] brcm_wlan_power Enter: power on
- <6>[28580.529006] [TSP] DVFS Off!wifi_set_carddetect = 1
- <4>[28580.741214] bcmsdh_sdmmc: probe of mmc2:0001:1 failed with error -123
- <4>[28580.741367] bcmsdh_sdmmc: probe of mmc2:0001:2 failed with error -123
- <6>[28580.745182] mmc2: card 0001 removed
- <4>[28580.821849] mmc2: queuing unknown CIS tuple 0x80 (7 bytes)
- <4>[28580.824962] mmc2: queuing unknown CIS tuple 0x80 (6 bytes)
- <6>[28580.917378] mmc2: new high speed SDIO card at address 0001
- <4>[28580.918659] alloc static buf at de100000!
- <4>[28580.919544] dhdsdio_probe : no mutex held. set lock
- <4>[28580.919758] F1 signature read @0x18000000=0x16034334
- <4>[28580.927877] DHD: dongle ram size is set to 524288(orig 524288)
- <4>[28580.929128] CHIP VER = [0x3]
- <4>[28580.929128] ----- CHIP bcm4334_B2 -----
- <6>[28580.931142] CFG80211-INFO2) wl_cfg80211_attach : wl_cfg80211_attach: wl = 0xda617b00
- <6>[28580.931203] CFG80211-INFO2) wl_create_event_handler : Enter
- <6>[28580.931203] CFG80211-INFO2) wl_create_event_handler : wl = 0xda617b00, wl->event_tsk = 0xda617cfc
- <4>[28580.931325] wl_create_event_handler thr:395d created
- <6>[28580.931356] CFG80211-INFO2) wl_event_handler : tsk Enter, tsk = 0xda617cfc
- <6>[28580.931447] CFG80211-INFO2) wl_event_handler : DAEMONIZE completed
- <6>[28580.931508] CFG80211-INFO2) wl_event_handler : wl_create_event_handler thr:395d started
- <4>[28580.931539] tsk completed
- <4>[28580.934805] p2p0: P2P Interface Registered
- <4>[28580.934866] dhd_attach thr:395e created
- <4>[28580.939139] dhd_attach thr:395e started
- <4>[28580.939200] dhd_attach thr:395f created
- <4>[28580.939322] dhd_attach thr:395f started
- <4>[28580.939383] dhd_attach thr:3960 created
- <4>[28580.939413] dhd_attach thr:3960 started
- <4>[28581.040527] dhdsdio_write_vars: Download, Upload and compare of NVRAM succeeded.
- <4>[28581.229784] dhd_wl_ioctl: WLC_GET_VAR: cisdump, ret = -23
- <4>[28581.230517] dhd_wl_ioctl: WLC_GET_VAR: cisdump, ret = -23
- <4>[28581.231585] dhd_wlfc_init(): successfully disabled bdcv2 tlv signaling, 0
- <4>[28581.239306] Firmware up: op_mode=5POWER_VAL = 1
- <4>[28581.302697] dhd_rx_frame: net device is NOT registered yet. drop packet
- <4>[28581.302880] dhd_rx_frame: net device is NOT registered yet. drop packet
- <4>[28581.304589] Firmware version = wl0: May 5 2012 04:02:57 version 6.10.58.474 (B2)
- <4>[28581.307672] Broadcom Dongle Host Driver: register interface [wlan0]dhdsdio_probe : the lock is released.
- <4>[28581.459206] firmware path changed:/system/etc/wifi/bcmdhd_sta.bin --> /system/etc/wifi/bcmdhd_apsta.bin
- <4>[28581.459236]
- <4>[28581.459236] Dongle Host Driver, version 1.15.15
- <4>[28581.459236] Compiled in drivers/net/wireless/bcmdhd/src on Jul 28 2012 at 21:23:32
- <4>[28581.459267] wl_android_wifi_off in
- <4>[28581.579120] wifi_set_power = 0
- <6>[28581.579151] ------------------------------------------------
- <6>[28581.579181] ------------------------------------------------
- <6>[28581.579212] brcm_wlan_power Enter: power off
- <4>[28581.579242] =========== WLAN placed in RESET ========
- <4>[28581.888994] wl_android_wifi_on in
- <4>[28581.889055] wifi_set_power = 1
- <6>[28581.889085] ------------------------------------------------
- <6>[28581.889116] ------------------------------------------------
- <6>[28581.889146] brcm_wlan_power Enter: power on
- <4>[28581.889177] =========== WLAN going back to live ========
- <4>[28582.199264] sdio_reset_comm():
- <4>[28582.207748] F1 signature read @0x18000000=0x16034334
- <4>[28582.224504] DHD: dongle ram size is set to 524288(orig 524288)
- <4>[28582.344785] dhdsdio_write_vars: Download, Upload and compare of NVRAM succeeded.
- <4>[28582.531539] Firmware up: op_mode=2[sec_control_pm, 883] /data/.psm.info open failed
- <4>[28582.541428] dhd_wl_ioctl: WLC_SET_VAR: arpoe, ret = -23
- <4>[28582.542160] dhd_wl_ioctl: WLC_SET_VAR: arp_ol, ret = -23
- <4>[28582.542893] dhd_wl_ioctl: WLC_SET_VAR: pkt_filter_add, ret = -23
- <4>[28582.543656] dhd_wl_ioctl: WLC_SET_VAR: pkt_filter_add, ret = -23
- <4>[28582.588917] Firmware version = wl0: May 5 2012 04:09:24 version 6.10.58.474 (SoftAP)
- <6>[28582.642297] CFG80211-INFO2) wl_cfg80211_set_channel : netdev_ifidx(28), chan_type(1) target channel(6)
- <4>[28582.828991] dhdsdio_clk_devsleep_iovar: No clock before enter sleep:0xc0
- <4>[28582.829082] dhdsdio_clk_devsleep_iovar: clock before sleep:0xc8
- <6>[28585.591298] max17040_work : VCELL:4325mV, AVGVCELL:4336mV
- <6>[28585.591359] max17040_work : Raw SOC:9909%, SOC:100%
- <6>[28585.593434] max17040_work : CONFIG:0x1c85, RATE:0x3500
- <6>[28585.594502] max17040_work : STATUS:0xff01, temperature:29
- <6>[28585.611167] max17040 13-0036: 40d8h,32c6h,0000h,1100h,0000h,1c85h,ffffh,ffffh,ffffh,ff00h,3500h,057dh,ff01h,ffffh,
- <7>[28593.528914] wlan0: no IPv6 routers present
Advertisement
Add Comment
Please, Sign In to add comment
Advertisement