U-Boot SPL 2014.04-00014-g3f788a1 (Apr 14 2014 - 17:02:51)
reading u-boot.img
reading u-boot.img


U-Boot 2014.04-00014-g3f788a1 (Apr 14 2014 - 17:02:51)

OMAP3630/3730-GP ES1.0, CPU-OPP2, L3-200MHz, Max CPU Clock 1 Ghz
OMAP3 Beagle board + LPDDR/NAND
I2C:   ready
DRAM:  512 MiB
NAND:  256 MiB
MMC:   OMAP SD/MMC: 0
*** Warning - bad CRC, using default environment

In:    serial
Out:   serial
Err:   serial
Beagle xM Rev A/B
Recognized Tincantools Trainer board (rev 0 0)
EEPROM is blank or 8bit addressing failed: retrying with 16bit:
i2c_read: error waiting for addr ACK (status=0x106)
No EEPROM on expansion board
Die ID #65f200001bf00000015739ea07019027
Net:   usb_ether
Hit any key to stop autoboot:  0
mmc0 is current device
gpio: pin 173 (gpio 173) value is 0
gpio: pin 4 (gpio 4) value is 0
SD/MMC found on device 0
reading uEnv.txt
1010 bytes read in 7 ms (140.6 KiB/s)
Loaded environment from uEnv.txt
Importing environment from mmc ...
Checking if lcdcmd is set ...
Checking if uenvcmd is set ...
Running uenvcmd ...
reading zImage
3418704 bytes read in 313 ms (10.4 MiB/s)
reading initrd.img
2836813 bytes read in 255 ms (10.6 MiB/s)
reading /dtbs/omap3-beagle-xm-ab.dtb
60695 bytes read in 23 ms (2.5 MiB/s)
## Error: "expansion_args" not defined
Kernel image @ 0x80300000 [ 0x000000 - 0x342a50 ]
## Flattened Device Tree blob at 815f0000
   Booting using the fdt blob at 0x815f0000
   Using Device Tree in place at 815f0000, end 81601d16

Starting kernel ...

Uncompressing Linux... done, booting the kernel.
[    0.166717] dpll3_m2_clk rate change failed: -22
[    0.167907] platform 480c5000.aes: Cannot lookup hwmod 'aes'
[    0.181335] platform 480c3000.sham: Cannot lookup hwmod 'sham'
[    0.188568] Could not look up dss_hdmi hw_mod
[    0.226226] musb-omap2430 480ab000.usb_otg_hs: invalid resource
[    0.930480] empty DMA controller list
[    0.934356] empty DMA controller list
[    0.938385] empty DMA controller list
[    0.942260] empty DMA controller list
[    0.946136] empty DMA controller list