case 3: //Pin mappings as per the androidcho's SimpleECU v1.0 PCB
	  //High current outputs (exactly the same), ready for programmable outputs
      pinInjector1 = 6; //Output pin injector 1, PCB Pin - HC1
      pinInjector2 = 7; //Output pin injector 2, PCB Pin - HC2
      pinInjector3 = 4; //Output pin injector, PCB Pin - HC3
      pinInjector4 = 5; //Output pin injector, PCB Pin - HC4
	  pinFan = 9; //Pin for the fan output, PCB Pin - HC5
	  pinFuelPump = 8; //Fuel pump output, PCB Pin - HC6
	  pinTachOut = 11; //Tacho output pin, PCB Pin - HC7
	  //pinVVT = 10; //Enough high current outputs, we have place for dedicated VVT out, PCB Pin - HC8
      pinIdle1 = 2; //Single wire idle control, PCB Pin - HC9
      pinIdle2 = 3; //2 wire idle control, PCB Pin - HC10
	  //Non-programmable low current outputs, used for coil outputs
	  //PNP transistors, "Going High" in Tunerstudio
	  pinCoil1 = 48; //Pin for coil 1, PCB Pin - IGN1
      pinCoil2 = 44; //Pin for coil 2, PCB Pin - IGN2
      pinCoil3 = 32; //Pin for coil 3, PCB Pin - IGN3
      pinCoil4 = 36; //Pin for coil 4, PCB Pin - IGN4
      //Inputs
      pinTrigger = 18; //The CAS(Crank) pin
      pinTrigger2 = 19; //The Cam pin
	  pinTPS = A4; //TPS input pin
      pinMAP = A2; //MAP sensor pin
      pinIAT = A1; //IAT sensor pin
      pinCLT = A0; //CLT sensor pin
      pinO2 = A3; //O2 Sensor pin
      pinBat = A15; //Battery reference voltage pin
      pinStepperDir = 17; //Direction pin for DRV8825 driver
      pinStepperStep = 16; //Step pin for DRV8825 driver
      pinLaunch = A5; //Can be overwritten below, pulled up by 10k and protected, PCB Pin - D1
	  //pinAnalogDigitalIn2 = A6; //Spare analog input, pulled up by 10k and protected, PCB Pin - D2
      pinDisplayReset = 48; //OLED reset pin
	  break;