BigReactor-eg1-Carbonated

-- credits to:
-- https://youtu.be/sHN-KQKUkaY
-- Modified for early game non advanced computer, no turbine, 2x1 monitor...
-- This program will later be replaced by a late early game version when I get a enderio capacitor...
-- A previous version had color and a 2x2 monitor, this version currently replaces that version.

-- when you connect the periphrials, check the log, these values should match what's in the code, if not
-- you need to change it...
-- [19:07:21] [Client thread/INFO]: [CHAT] Peripheral "computer_12" connected to network
-- [19:07:24] [Client thread/INFO]: [CHAT] Peripheral "monitor_4" connected to network
-- [19:07:27] [Client thread/INFO]: [CHAT] Peripheral "BigReactors-Reactor_6" connected to network

-- basic setup for this...
-- reactor has a computer port

-- This isn't complex, but that's what I like about it.  It doesn't auto configure or do anything fancy, it just monitors
-- what you tell it, and turns the reactor on and off to conserve fuel...
-- for an api reference, I use and recommend:
-- http://ftbwiki.org/Reactor_Computer_Port
-- http://ftbwiki.org/Turbine_Computer_Port

-- I've further decided to stop treating the reactor like a reactor, instead of messing with the control rods the
-- turbine works best with the rods set to 20%, so I'll just leave it at 20%, and shut it off when it's full.

  local reactor1 = peripheral.wrap("BigReactors-Reactor_6")
  local mon = peripheral.wrap("monitor_4")

while true do
  -- basic capacitor low, 10k of 100k capacity
  local low = 10000
  -- turbine high 800k 1000000 capacity
  local high = 800000
  -- reactor full at 10M
  local full = 10000000

  if reactor1.getEnergyStored() <= low then
    reactor1.setAllControlRodLevels(20)
    if reactor1.getActive() == false then
      reactor1.setActive(true)
    end
  end

  if reactor1.getEnergyStored() == full then
     reactor1.setActive(false)
  else
    if reactor1.getEnergyStored() >= high then
      reactor1.setAllControlRodLevels(90)
      reactor1.setActive(true)
    end
  end

  mon.clear()

  mon.setCursorPos(1,1)
  mon.write("Active: ")
  mon.write(reactor1.getActive())

  mon.setCursorPos(1,2)
  mon.write("Casing Heat: ")
  mon.write(math.floor(reactor1.getCasingTemperature()))

  mon.setCursorPos(1,3)
  mon.write("Fuel Heat: ")
  mon.write(math.floor(reactor1.getFuelTemperature()))

  mon.setCursorPos(1,4)
  mon.write("RF: ")
  mon.write(math.floor(reactor1.getEnergyStored()))

  sleep(10)
end