Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- <4>## wifi_probe
- <4>wifi_set_power = 1
- <4>htcleo_wifi_power: 1
- <4>wifi_set_carddetect = 1
- <6>htcleo_wifi_set_carddetect: 1
- <7>mmc0: card_present 1
- <6>mmc0: Slot status change detected (0 -> 1)
- <4>
- <4>Dongle Host Driver, version 5.90.195.75
- <4>Compiled in drivers/net/wireless/bcmdhd on Mar 28 2014 at 14:40:44
- <6>Audio: htcleo_get_rx_vol 260
- <4>$$ DEV=01081513: vol is 260
- <4>audio_cb: s=1 e=0107605c status=20
- <6>[ATS][set_vibration][successful]
- <6>[VIB]gpio_timer_func
- <4>mmc0: queuing unknown CIS tuple 0x91 (3 bytes)
- <6>mmc0: new high speed SDIO card at address 0001
- <4>F1 signature read @0x18000000=0x9934329
- <4>DHD: dongle ram size is set to 294912(orig 294912)
- <4>wl_create_event_handler thr:24b started
- <4>dhd_attach thr:24c started
- <4>dhd_attach thr:24d started
- <4>dhd_attach thr:24f started
- <4>wifi_get_mac_addr
- <4>Broadcom Dongle Host Driver: register interface [wlan0] MAC: 00:90:4c:11:22:33
- <4>wifi_set_power = 0
- <4>htcleo_wifi_power: 0
- <4>bcmsdh_sdmmc: probe of mmc0:0001:3 failed with error -110
- <4>=========== WLAN placed in RESET ========
- <6>warning: `wpa_supplicant' uses 32-bit capabilities (legacy support in use)
- <4>
- <4>Dongle Host Driver, version 5.90.195.75
- <4>Compiled in drivers/net/wireless/bcmdhd on Mar 28 2014 at 14:40:44
- <4>wl_android_wifi_on in
- <4>wifi_set_power = 1
- <4>htcleo_wifi_power: 1
- <4>=========== WLAN going back to live ========
- <4>sdio_reset_comm():
- <4>dhdsdio_write_vars: Download, Upload and compare of NVRAM succeeded.
- <4>wifi_get_mac_addr
- <4>Firmware up: op_mode=1, Broadcom Dongle Host Driver mac=00:23:76:c9:5d:17
- <4>Firmware version = wl0: May 25 2012 17:57:45 version 4.218.248.44
- <3>CFGP2P-ERROR) wl_cfgp2p_supported : wl p2p error -23
- <3>CFG80211-ERROR) wl_construct_reginfo : get chanspecs failed with -23
- <3>CFG80211-ERROR) wl_update_wiphybands : wl_construct_reginfo() fails err=-23
- <3>CFG80211-ERROR) wl_construct_reginfo : get chanspecs failed with -23
- <3>CFG80211-ERROR) wl_update_wiphybands : wl_construct_reginfo() fails err=-23
- <3>WLDEV-ERROR) wldev_set_country : wldev_set_country: set country for LB as LB rev -1
- <3>CFG80211-ERROR) wl_construct_reginfo : get chanspecs failed with -23
- <3>CFG80211-ERROR) wl_update_wiphybands : wl_construct_reginfo() fails err=-23
- <4>[D:BATT] V=4155(6a7) I=88(df) C=1222.0/1230(1102) id=4(a7) T=360(cc) KADC=1000
- <4>[D:BATT] acr update: P=990, C=4340.
- <4>[D:BATT]new RARC=990 C=1217mAh adc=4340.
- <4>[D:BATT] state change(2->3), full count=0, over load count=0 [432434296]
- <6>Release 'boot-time' no_halt_lock
- <2>kgsl kgsl-3d0: |kgsl_gpummu_pagefault| mmu page fault: page=0x6af50000 pt=0 op=WRITE axi=4
Advertisement
Add Comment
Please, Sign In to add comment