Guest User

Only red light after update rasperry-firmware

a guest
Jul 31st, 2013
148
0
Never
Not a member of Pastebin yet? Sign Up, it unlocks many cool features!
Bash 1.63 KB | None | 0 0
  1. cmdline.txt:
  2. sdhci-bcm2708.enable_llm=1 sdhci-bcm2708.sync_after_dma=0 dwc_otg.lpm_enable=0 console=ttyAMA0,115200 kgdboc=ttyAMA0,115200 console=tty1 loglevel=2 root=/dev/mmcblk0p2 init=/bin/systemd rootfstype=ext4 rootwait
  3.  
  4. config.txt:
  5. # uncomment if you get no picture on HDMI for a default "safe" mode
  6. #hdmi_safe=1
  7.  
  8. # uncomment this if your display has a black border of unused pixels visible
  9. # and your display can output without overscan
  10. #disable_overscan=1
  11.  
  12. # uncomment the following to adjust overscan. Use positive numbers if console
  13. # goes off screen, and negative if there is too much border
  14. #overscan_left=18
  15. #overscan_right=18
  16. #overscan_top=28
  17. #overscan_bottom=18
  18.  
  19. # uncomment to force a console size. By default it will be display's size minus
  20. # overscan.
  21. #framebuffer_width=1280
  22. #framebuffer_height=720
  23.  
  24. # uncomment if hdmi display is not detected and composite is being output
  25. #hdmi_force_hotplug=1
  26.  
  27. # uncomment to force a specific HDMI mode (this will force VGA)
  28. #hdmi_group=1
  29. #hdmi_mode=1
  30.  
  31. # uncomment to force a HDMI mode rather than DVI. This can make audio work in
  32. # DMT (computer monitor) modes
  33. #hdmi_drive=2
  34.  
  35. # uncomment to increase signal to HDMI, if you have interference, blanking, or
  36. # no display
  37. #config_hdmi_boost=7
  38.  
  39. # uncomment for composite PAL
  40. #sdtv_mode=2
  41.  
  42. #uncomment to overclock the arm. 700 MHz is the default.
  43. #arm_freq=800
  44.  
  45. #arm_freq=950
  46. #core_freq=450
  47. #sdram_freq=450
  48. #over_voltage=6
  49.  
  50. #arm_freq=1000
  51. #core_freq=500
  52. #sdram_freq=500
  53. #over_voltage=6
  54.  
  55.  
  56. gpu_mem=128
  57.  
  58.  
  59.  
  60. decode_MPG2=0xXXXXXXXX
  61. decode_WVC1=0xXXXXXXXX
  62.  
  63. # for more options see http://elinux.org/RPi_config.txt
Advertisement
Add Comment
Please, Sign In to add comment