Failed PowerEdge R420 after iDrac VV01T 2.21.21.21_A00

U-Boot 2009.08 (Nov 04 2015 - 11:28:55) Avocent (0.0.3) EVB

CPU: SH-4A
BOARD: R0P7757LC00xxRL (Cn step) board
BOOT: Secure, HRK generated
DRAM:  240MB
  (240MB of 256MB total DRAM is available on U-Boot)
ENV:   Using primary env area.
In:    serial
Out:   serial
Err:   serial
PCIe:  Bridge loaded with 0x18000 bytes
WDT2:  Booted Lower Vector, 'uboot1'
sh_mmcif: 0, sh-sdhi: 1
Net:   sh_eth.0, sh_g_eth.0
INFO: 00:002 Start-up -to- util_idrac_main()
INFO: 00:004 U-Boot 2009.08 (Nov 04 2015 - 11:28:55) Avocent (0.0.3) EVB
INFO: 00:007 U-Boot checkin date(08-04-2015) Version(1.1.31)
INFO: 00:006 iDRAC PPID <NULL>
INFO: 00:003 SPI NOR init 4096 KiB N25Q032 bus=0 cs=0, speed=1000000, mode=3
INFO: 00:007 SH-4A Product: Major Ver=0x31  Minor Ver=0x13 C3 Little endian
             Family=0x10    Major Ver=0x30  Minor Ver=0x0b
INFO: 00:139 BCM5221 OUI=0x000000  Model=0x00  Revision=0x00 PhyAddr=4
INFO: 00:007 Dedicated monolithic mgmt NIC disabled
INFO: 00:004 SD CARD: is not found
INFO: 00:041 EMMC:   Device: sh_mmcif   Manufacturer ID: 15   OEM: 100
             Name: M4G1E   Tran Speed: 25000000   Rd Blk Len: 512
             MMC ver 4.0   HC: Yes   cap(<2gb): 0  cap(>2gb): 7815168
             ext_rev: 3    rst_n: 0  ext[96]: 0
INFO: 00:023 CPLD: Major Ver=0x1  Minor Ver=0x0  Maint Ver=0x4
             Planar: Type=0x09  Rev=0x4  Rework=0x0  Scratch/PathRetry=0x00
PASS: 00:014 Coin cell detected good,  AD=0x373 low water=0x2c1
PASS: 00:008 PCIe SH7757_C0 Ver=0.15 MCTP en, CRC=0x8e9b6875 @0x8efbd704 cnt=0x18000
INFO: 00:008 Init PCIe mailbox(PCIe 0xFFEE0150=0x40010000)
INFO: 00:006 mode=normal
INFO: 00:002 reset_cause=ac
PASS: 00:005 Booted Lower Vector, 'uboot1' wdt2cnt=0
INFO: 00:005 wdt0cnt=0  cpld_recover_cnt=0  ddr_recover_cnt=0
PASS: 00:007 Clear CH1/CH2, clear 4K shared memory@0xffcaa000 on AC power up
PASS: 00:007 SMR0 no sermux env, default 0xd4
INFO: 00:004 GRACR=0x3c HISEL=0x00 SIRQCR5_D=0x03 SIRQCR6_D=0x01 LADMSK0=0xff2
             MRSTCR0=0xfedffe7f MRSTCR1=0xfff3ff0f MRSTCR2=0x6f80feff
             BARMAP=0x1 BCR=0x85000000 NCER=0x01fc NCMCR=0x0006 NCCSR=0x0303
PASS: 00:022 etherc0=90:B1:1C:27:A4:03
             getherc0=90:B1:1C:27:A4:04
INFO: 00:009 Fan logic for monolithic planar type 9
             fan1 - def 0000 1fff 3d   fan2 - def 0000 1fff 3d
             fan3 - def 0000 1fff 3d   fan4 - def 0000 1fff 3d
             fan5 - def 0000 1fff 3d   fan6 - def 0000 1fff 3d
             fan7 - def 0000 1fff 3d   fan8 - def 0000 1fff 3d
INFO: 00:076 Env and backup CRC'ed ok
Erasing SPI flash at 0x100000...Writing to SPI flash...done
Erasing SPI flash at 0x110000...Writing to SPI flash...done
*** no text signature found ***
INFO: 02:582 Sync eMMC/SPI NOR/Alternate u-boot images
PASS: 00:269 Current u-boot1 1.1.31 verified with 'ubootN'
             Trailer Struct - Missing start token, exp=0xc0de1111 rec=0x0
             U-boot2 in sync with u-boot1 1.1.31
PASS: 07:460 Verify OS Images N: CRC32 OK: Kernel=0xc4135ec5 Rootfs=0x47eca7d
PASS: 00:007 Boot device=emmc  Boot partition1/N
             Boot Path Retry:P1/N=0 P5/N-1=0
INFO: 00:000 10:743


WDT2: Disabled
Initialization complete, proceed with boot
OS_WDT0_EN:180 seconds,  Re-load ILRAM:
SPI_WP: Not attempted.
EMMC_WP: Not attempted.
Boot Path Retry:P1/N=0 P5/N-1=0
Copying kernel image ... OK
## Booting kernel from Legacy Image at 88000000 ...
   Image Name:   sh-linux
   Image Type:   SuperH Linux Kernel Image (gzip compressed)
   Data Size:    2625419 Bytes =  2.5 MB
   Load Address: 80001000
   Entry Point:  80002000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK
WDT2: Disable in do_bootm_linux()

Monolithic/DRB
mmc1: error -22 whilst initialising SDIO card
mmc1: error -22 whilst initialising MMC card
systemd[1]: could not find module by name='autofs4'
systemd[1]: Failed to insert 'autofs4'
mmc1: error -22 whilst initialising SDIO card
mmc1: error -22 whilst initialising MMC card
mmc1: error -22 whilst initialising SDIO card
mmc1: error -22 whilst initialising MMC card

Welcome to developer console!
Type "journalctl -b" to view system logs. Type "systemctl reboot" to reboot.
/home/root #