Error Message

U-Boot SPL 2013.10-dirty (Nov 14 2013 - 16:40:50)
reading args
spl: error reading image args, err - -1
reading u-boot.img
reading u-boot.img


U-Boot 2013.10-dirty (Nov 14 2013 - 16:40:50)

I2C:   ready
DRAM:  256 MiB
WARNING: Caches not enabled
NAND:  0 MiB
MMC:   OMAP SD/MMC: 0, OMAP SD/MMC: 1
*** Warning - readenv() failed, using default environment

Net:   <ethaddr> not set. Validating first E-fuse MAC
cpsw, usb_ether
Hit any key to stop autoboot:  0
gpio: pin 53 (gpio 53) value is 1
mmc0 is current device
gpio: pin 54 (gpio 54) value is 1
SD/MMC found on device 0
reading uEnv.txt
335 bytes read in 4 ms (81.1 KiB/s)
Importing environment from mmc ...
gpio: pin 55 (gpio 55) value is 1
Checking if uenvcmd is set ...
gpio: pin 56 (gpio 56) value is 1
Running uenvcmd ...
## Error: "loaduimage" not defined
Booting from mmc ...
Bad Linux ARM zImage magic!

uenvcmd was not defined in uEnv.txt ...
trying eMMC (BeagleBone Black) ...

Card did not respond to voltage select!
mmc1(part 0) is current device
Card did not respond to voltage select!