* Kyle Santos takes a Set of 4' BFGoodrich ALL-TERRAIN T/A KO On-/Off-Road All-Terrain tires (LT245/70R17) from the 1996 Nissan
 240SX. *
★ Kyle Santos grabs the jack from under the shelves
★ Kyle Santos drags it over to the Hummer.
★ Kyle Santos keels down finding an assembly point on the chassis to the jack
★ Kyle Santos aligns the jack up with the assembly point and starts leveraging himself on the lever
★ Kyle Santos grabs the lever moving it up and down several times until the wheels are off the ground.
★ Kyle Santos grabs an electric wrench from the shelf plugging it into a socket
★ Kyle Santos twists a bolt head into the housing
★ Kyle Santos twists the electric wrench attatching it to the hubcaps
★ Kyle Santos applies a slight bit of pressure to to the trigger loosening the hubcap
★ Same would be done to the 4 other hubcaps      ((Kyle Santos))
★ Kyle Santos takes the hubcaps and places them into a bucket on the shelf
★ THIS WOULD ALLOW THE BOLTS HOLDING THE WHEEL IN PLACE TO BE EXPOSED      ((Kyle Santos))
★ Kyle Santos twists the electric wrench this time tightening it harder to the wheel bearing bolts
★ Kyle Santos applies a slighter more value of pressure untightening the wheel bearing bolt
★ Kyle Santos places the bolt on the floor next to him
★ Kyle Santos does the same to the other 4 wheel bearing bolts stacking the ontop of each other
★ THIS WOULD LET THE WHEEL LOOSE      ((Kyle Santos))
★ Kyle Santos twists the tire/wheel forwards and backwards until it comes of swiftly
 Kyle Santos twists the tire/wheel forwards and backwards until it comes of swiftly
★ Kyle Santos rolls the wheel over to the tire changer
★ Kyle Santos picks it up carefulling stacking it on the housing of the tirechanger
★ Kyle Santos twists the aircap allowing a few moments for the tire to deflat
★ Kyle Santos feels the tire making sure its deflated. Grabs the tire changer hand and wedges it between -
★ - rim and wheel      ((Kyle Santos))
★ Kyle Santos grabs the lever ontop of the tire changer hand pulling it down
★ THIS WOULD MAKE THE RIM SIDE POP OFF OF THE TIRE      ((Kyle Santos))
★ Kyle Santos locks the hand in place turning the tire change switch on
★ YOU WOULD SEE THE TIRE GET TURNED AROUND POPPING THE RIM OFF EVERY SIDE      ((Kyle Santos))
★ Kyle Santos flicks it off after see-ing the rim has full popped off
★ Kyle Santos takes the rim off the tire placing it on the floor carefully
★ Kyle Santos grabs the tire and rolls it to the tire stack
★ The new tires would be on the ground in a large carboard box      ((Kyle Santos))
★ Kyle Santos reaches into his inside blazer pocket grabbing an unboxing knife
★ Kyle Santos passes the blade threw the tape
★ The cardboard box would open      ((Kyle Santos))
Kyle Santos: (( through the tape* ))
★ Kyle Santos grabs the new tire popping it onto the tire changer
★ Kyle Santos grabs the rim carefully from the floor stacking it ontop off the tire
★ Kyle Santos grabs a tire iron from the shelf
* Kyle Santos takes a Tire Iron from the shelf. *
★ Kyle Santos puts the tire changer hand on the right side of the tire flicking the switch
★ THE HAND WOULD MOVE STRETCHING THE TIRE OUT ONE WAY      ((Kyle Santos))
★ Kyle Santos wedges the tire iron towards the tire stretching it out to the left
★ THE RIM WOULD POP ON BOTH SIDES      ((Kyle Santos))
★ Kyle Santos takes the tire iron from the tire wedging it downwards
★ Kyle Santos twists  the hand towards the upwards way of the tire
★ Kyle Santos flicks a red switch allowing the hand to stretch it out upwards
★ Kyle Santos applies force on the tire iron  stretching it out downwards
★ THE RIM WOULD POP ON FULLY      ((Kyle Santos))
★ Kyle Santos flicks the switch once more allow it to retreat from inbetween tire and rim
★ Kyle Santos switches the tire changer to inflate mode grabbing the tube
★ Kyle Santos twists the tube onto the air dock in the tire
★ Kyle Santos sets it to 40DPI waiting a moment before it beeps
★ BEEP BEEP BEPP      ((Kyle Santos))
★ Kyle Santos grabs the aircap with the right hand while unscrewing the inflator tube from the housing
★ Kyle Santos quickly screws the aircap back on not allowing any air in or out
★ Kyle Santos takes the wheel out from the housing rolling it towards the hummer
★ Kyle Santos kneels down picking the wheel up placing it on the wheel bearing housing
★ Kyle Santos grabs the stacked wheel bearing bolts twisting them on one by one
★ Kyle Santos walks over to the electric wrench picking it up (STILL WITH THE BOLT HEAD ON)
★ Kyle Santos twists the bolt head onto the wheel bearing bolts tightening the to a safe force
★ Kyle Santos does the same to the other 4 bolts nodding to himself.
★ Kyle Santos grabs some dark spray polish spraying it on a clean rag
★ Kyle Santos grabs the clean rag and scrubs on the rim ensuring any scratches are gone and -
★ - it looks prestine and clean      ((Kyle Santos))