usbboot - Ingenic XBurst USB Boot Utility
(c) 2009 Ingenic Semiconductor Inc., Qi Hardware Inc., Xiangfu Liu, Marek Lindner
This program is Free Software and comes with ABSOLUTELY NO WARRANTY.

Now checking whether all configure args valid: YES
Current device information:
CPU type is Ingenic XBurst Jz4740
Crystal work at 12MHz, the CCLK up to 252MHz and PMH_CLK up to 84MHz
SDRAM Total size is 32 MB, work in 4 bank and 16 bit mode
Nand page per block 128, Nand page size 4096, ECC offset in OOB 12, bad block offset in OOB 0, bad block page 127, use 1 plane mode
 Execute command: nprog 1024 openwrt-xburst-qi_lb60-uImage.bin 0 0 -n
 Programing No.0 device, flen 1737523, start page 1024...
 CPU data: Boot4740
 Erasing No.0 device No.0 flash (start_blk 8 blk_num 4)......
 Finish! Return: 00 08 00 00 00 00 00 00 (position 16)
 There are marked bad blocks: 4
 Size to send 1737523, transfer_size 524288
 Image type : without oob
 It will cause 4 times buffer transfer.
 Writing NAND page 1024 len 524288...
 CPU data: Boot4740
 Finish! (len 524288 start_page 1024 page_num 128)
 Checking 524288 bytes... Comparing 524288 bytes - SUCCESS
 End at Page: 1152
 Writing NAND page 1152 len 524288...
 CPU data: Boot4740
 Finish! (len 524288 start_page 1152 page_num 128)
 Checking 524288 bytes... Comparing 524288 bytes - SUCCESS
 End at Page: 1280
 Writing NAND page 1280 len 524288...
 CPU data: Boot4740
 Finish! (len 524288 start_page 1280 page_num 128)
 Checking 524288 bytes... Comparing 524288 bytes - SUCCESS
 End at Page: 1408
 Writing NAND page 1408 len 167936...
 CPU data: Boot4740
 Finish! (len 167936 start_page 1408 page_num 41)
 Checking 167936 bytes... Comparing 167936 bytes - SUCCESS
 End at Page: 1577
 Skip a old bad block ![root@boggieman nanodebian]#