Advertisement
Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- [ 6402.411018] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
- [ 6402.411023] cfg80211: Updating information on frequency 2462 MHz for a 20 MHz width channel with regulatory rule:
- [ 6402.411029] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
- [ 6402.411034] cfg80211: Disabling freq 2467 MHz
- [ 6402.411037] cfg80211: Disabling freq 2472 MHz
- [ 6402.411044] cfg80211: Regulatory domain changed to country: US
- [ 6402.411048] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
- [ 6402.411054] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
- [ 6402.411060] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm)
- [ 6402.411065] cfg80211: (5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
- [ 6402.411070] cfg80211: (5490000 KHz - 5600000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
- [ 6402.411075] cfg80211: (5650000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
- [ 6402.411080] cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm)
- [ 6404.919471] iwlwifi 0000:03:00.0: Tx aggregation enabled on ra = 00:18:0a:36:b4:9e tid = 0
- [ 6644.866456] wlan0: direct probe to 00:18:0a:36:af:64 (try 1/3)
- [ 6644.873548] wlan0: direct probe responded
- [ 6644.897990] wlan0: authenticate with 00:18:0a:36:af:64 (try 1)
- [ 6644.900266] wlan0: authenticated
- [ 6645.045223] wlan0: associate with 00:18:0a:36:af:64 (try 1)
- [ 6645.049581] wlan0: RX ReassocResp from 00:18:0a:36:af:64 (capab=0x31 status=0 aid=5)
- [ 6645.049591] wlan0: associated
- [ 6645.049599] wlan0: No basic rates in AssocResp. Using min supported rate instead.
- [ 6652.205404] iwlwifi 0000:03:00.0: Tx aggregation enabled on ra = 00:18:0a:36:af:64 tid = 0
- [ 7279.479112] usb 3-1: USB disconnect, device number 5
- [ 7279.479510] rndis_host 3-1:1.0: eth1: unregister 'rndis_host' usb-0000:0f:00.0-1, RNDIS device
- [ 7279.486171] e1000e: eth0 NIC Link is Down
- [ 7279.511899] sd 8:0:0:0: [sdc] Synchronizing SCSI cache
- [ 7279.511940] sd 8:0:0:0: [sdc] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK
- [ 7283.809696] ADDRCONF(NETDEV_UP): eth0: link is not ready
- [ 7290.294896] e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow Control: None
- [ 7290.294909] e1000e 0000:00:19.0: eth0: 10/100 speed: disabling TSO
- [ 7290.296434] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
- [ 7291.434720] e1000e: eth0 NIC Link is Down
- [ 7293.215114] e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow Control: None
- [ 7293.215126] e1000e 0000:00:19.0: eth0: 10/100 speed: disabling TSO
- [ 7300.586616] eth0: no IPv6 routers present
- [ 7333.353198] e1000e: eth0 NIC Link is Down
- [ 7335.294342] e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow Control: None
- [ 7335.294355] e1000e 0000:00:19.0: eth0: 10/100 speed: disabling TSO
- [ 7337.441969] e1000e: eth0 NIC Link is Down
- [ 7339.095262] e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow Control: None
- [ 7339.095274] e1000e 0000:00:19.0: eth0: 10/100 speed: disabling TSO
- [ 7747.166904] e1000e: eth0 NIC Link is Down
- [ 7751.443944] ADDRCONF(NETDEV_UP): eth0: link is not ready
- [ 7776.141016] usb 3-1: new high-speed USB device number 6 using xhci_hcd
- [ 7776.167127] rndis_host 3-1:1.0: eth1: register 'rndis_host' at usb-0000:0f:00.0-1, RNDIS device, c8:a0:30:ab:59:92
- [ 7776.168286] cdc_acm 3-1:1.2: This device cannot do calls on its own. It is not a modem.
- [ 7776.168394] cdc_acm 3-1:1.2: ttyACM0: USB ACM device
- [ 7776.170488] scsi10 : usb-storage 3-1:1.4
- [ 7777.168788] scsi 10:0:0:0: Direct-Access Linux File-CD Gadget 0308 PQ: 0 ANSI: 2
- [ 7777.170268] sd 10:0:0:0: Attached scsi generic sg1 type 0
- [ 7777.170551] sd 10:0:0:0: [sdb] 144522 512-byte logical blocks: (73.9 MB/70.5 MiB)
- [ 7777.170721] sd 10:0:0:0: [sdb] Write Protect is off
- [ 7777.170728] sd 10:0:0:0: [sdb] Mode Sense: 0f 00 00 00
- [ 7777.170888] sd 10:0:0:0: [sdb] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
- [ 7777.189113] sdb:
- [ 7777.190945] sd 10:0:0:0: [sdb] Attached SCSI removable disk
- [ 7786.922463] eth1: no IPv6 routers present
- [ 9720.042736] usb 2-1.2: new high-speed USB device number 6 using ehci_hcd
- [ 9720.142145] scsi11 : usb-storage 2-1.2:1.0
- [ 9721.142624] scsi 11:0:0:0: Direct-Access Generic USB SD Reader 1.00 PQ: 0 ANSI: 0 CCS
- [ 9721.145040] sd 11:0:0:0: Attached scsi generic sg2 type 0
- [ 9721.146705] sd 11:0:0:0: [sdc] 15564800 512-byte logical blocks: (7.96 GB/7.42 GiB)
- [ 9721.147332] sd 11:0:0:0: [sdc] Write Protect is off
- [ 9721.147345] sd 11:0:0:0: [sdc] Mode Sense: 4b 00 00 08
- [ 9721.149753] sd 11:0:0:0: [sdc] No Caching mode page present
- [ 9721.149762] sd 11:0:0:0: [sdc] Assuming drive cache: write through
- [ 9721.153319] sd 11:0:0:0: [sdc] No Caching mode page present
- [ 9721.153327] sd 11:0:0:0: [sdc] Assuming drive cache: write through
- [ 9721.154343] sdc: sdc1 sdc2
- [ 9721.156817] sd 11:0:0:0: [sdc] No Caching mode page present
- [ 9721.156829] sd 11:0:0:0: [sdc] Assuming drive cache: write through
- [ 9721.156838] sd 11:0:0:0: [sdc] Attached SCSI removable disk
- [ 9721.556511] EXT4-fs (sdc2): mounted filesystem with ordered data mode. Opts: (null)
- [ 9848.268589] sdc: detected capacity change from 7969177600 to 0
- [10220.058340] usb 2-1.2: USB disconnect, device number 6
- [10436.820069] usb 2-1.2: new high-speed USB device number 7 using ehci_hcd
- [10436.918820] scsi12 : usb-storage 2-1.2:1.0
- [10437.916158] scsi 12:0:0:0: Direct-Access Generic USB SD Reader 1.00 PQ: 0 ANSI: 0 CCS
- [10437.917639] sd 12:0:0:0: Attached scsi generic sg2 type 0
- [10437.919123] sd 12:0:0:0: [sdc] 15564800 512-byte logical blocks: (7.96 GB/7.42 GiB)
- [10437.919802] sd 12:0:0:0: [sdc] Write Protect is off
- [10437.919812] sd 12:0:0:0: [sdc] Mode Sense: 4b 00 00 08
- [10437.921022] sd 12:0:0:0: [sdc] No Caching mode page present
- [10437.921035] sd 12:0:0:0: [sdc] Assuming drive cache: write through
- [10437.925327] sd 12:0:0:0: [sdc] No Caching mode page present
- [10437.925337] sd 12:0:0:0: [sdc] Assuming drive cache: write through
- [10437.926231] sdc: sdc1 sdc2
- [10437.928958] sd 12:0:0:0: [sdc] No Caching mode page present
- [10437.928970] sd 12:0:0:0: [sdc] Assuming drive cache: write through
- [10437.928980] sd 12:0:0:0: [sdc] Attached SCSI removable disk
- [10438.535957] EXT4-fs (sdc2): mounted filesystem with ordered data mode. Opts: (null)
- [10581.436160] sdc: detected capacity change from 7969177600 to 0
Advertisement
Add Comment
Please, Sign In to add comment
Advertisement