Advertisement
Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- Balloon Launch Day Checklist
- • Initial Setup
- • Take out supplies (tools, balloon items, etc)
- • Layout and stake tarp
- • Roll out He tank
- • Attach regulator to He tank
- • Set up Payload (While Initial Setup is taking place)
- • Check all power, connection cables & scientific devices (batteries, ardunio, sensors)
- • Check GoPro settings (focus @ infinity, high resolution, no flash, empty SD)
- • Check camera to make sure it is recording
- • Check radio (make sure its on, sending out a signal, antenna attached)
- • Check Pocketfinder (make sure its on, finds location, charge)
- • Place handwarmer in but do not activate
- • Check parachute
- • Mass Payload & parachute
- • TURN BACK OFF ALL DEVICES!
- • Fill Balloon (PUT ON GLOVES!!!!!!)
- • Clean filling tube end with isopropyl alcohol
- • Blow out fill tube with He
- • PUT ON GLOVES!!!!!!
- • Attach filling device to balloon using zip ties & duct tape
- • Attach calibrated weight to filling device
- • Fill balloon with He until starts to float
- • Tie off balloon above the fill tube
- • Attach rope with 25 lb weight to tie off
- • Fold balloon stem over and duct tape
- • Securing Payload to balloon
- • Lay out lift train (rope, parachute, payload)
- • Untwist lift train rope
- • Attach lift train to balloon
- • Power Up
- • Power Up all devices
- • Put in hand warmers
- • Start camera, scientific, & tracking devices, CHECK ONE LAST TIME!!!!
- • SEAL PAYLOAD OFF WITH DUCT TAPE
- • Check rigging for tangles, check payload attachment
- • LIFT OFF!!!!!!
Advertisement
Add Comment
Please, Sign In to add comment
Advertisement