show interface Serial0/0/0

Serial0/0/0 is up, line protocol is up (looped)
Hardware is GT96K Serial
Internet address is 210.220.61.2/30
  MTU 1500 bytes, BW 1544 Kbit/sec, DLY 20000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation HDLC, loopback not set
  Keepalive set (10 sec)
  Last input 00:00:07, output 00:00:07, output hang never
  Last clearing of "show interface" counters 01:11:55
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     675 packets input, 48741 bytes, 0 no buffer
     Received 335 broadcasts (0 IP multicasts)
     0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     675 packets output, 48741 bytes, 0 underruns
     0 output errors, 0 collisions, 2 interface resets
     3 unknown protocol drops
     0 output buffer failures, 0 output buffers swapped out
     0 carrier transitions
     DCD=up  DSR=up  DTR=up  RTS=up  CTS=up

sh diag

WIC Slot 0:
        Serial 2T (12in1)
        Hardware revision 1.0           Board revision B0
        Serial number     36966334      Part number    800-03181-03
        Version Identifier     V01      FRU Part Number     WIC-2T
        Test history      0x0           RMA number     00-00-00
        Connector type    PCI
        EEPROM format version 1
        EEPROM contents (hex):
          0x20: 01 12 01 00 02 34 0F BE 50 0C 6D 03 00 00 00 00
          0x30: 58 00 00 00 09 09 06 00 FF FF FF FF FF FF FF FF

>(config)# card ?
% Unrecognized command
(config)# controller ?
% Unrecognized command