console log on nanoloco2

[   44.540000] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   44.690000] device wlan0 entered promiscuous mode
[   44.830000] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   44.920000] br-lan: port 2(wlan0) entered forwarding state
[   44.990000] br-lan: port 2(wlan0) entered forwarding state
[   45.050000] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   45.210000] device wlan0-1 entered promiscuous mode
[   45.400000] ADDRCONF(NETDEV_UP): wlan0-1: link is not ready
add wlan0-1
if wlan0-1 dev
[   46.990000] br-lan: port 2(wlan0) entered forwarding state
ifup loopback
if loopback dev lo
[   47.180000] br-lan: port 3(wlan0-1) entered forwarding state
[   47.250000] br-lan: port 3(wlan0-1) entered forwarding state
[   47.320000] ADDRCONF(NETDEV_CHANGE): wlan0-1: link becomes ready
[   47.820000] eth0: Configuring MAC for full duplex
[   49.250000] br-lan: port 3(wlan0-1) entered forwarding state
[   52.890000] ADDRCONF(NETDEV_UP): wlan0-2: link is not ready
[   56.380000] eth0: Configuring MAC for full duplex
[   60.040000] wlan0-2: Creating new IBSS network, BSSID 02:15:7a:d6:d5:b6
[   60.330000] ADDRCONF(NETDEV_CHANGE): wlan0-2: link becomes ready
[   61.940000] eth0: Configuring MAC for full duplex
ifup mesh0
if mesh0 dev wlan0-2
[   67.010000] batman_adv: bat0: Adding interface: wlan0-2
[   67.070000] batman_adv: bat0: Interface activated: wlan0-2
[   67.230000] device bat0 entered promiscuous mode
[   67.280000] br-lan: port 4(bat0) entered forwarding state
[   67.350000] br-lan: port 4(bat0) entered forwarding state
[   67.940000] batman_adv: bat0: Changing gw mode from: off to: client
[   68.210000] batman_adv: bat0: bridge_loop_avoidance: Changing from: disabled to: enabled
add bat0
if bat0 dev
[   69.350000] br-lan: port 4(bat0) entered forwarding state
[   70.510000] eth0: Configuring MAC for full duplex
[   76.070000] eth0: Configuring MAC for full duplex
ifup bat0
if bat0 dev bat0