23:37:24 < buZz> what does w/t stand for again?
23:37:32 < ccecil> width over thickness
23:37:33 < buZz> ah
23:37:42 < buZz> so a ratio
23:37:48 < ccecil> so .3 with a .66 is a 2.2
23:38:34 < ccecil> buZz:  I should say it properly, .66 line width divided by .3 layer height
23:38:43 < ccecil> gives 2.2 w/t
23:39:19 < buZz> ah yeah, and some w/t are bad, some are good, thats why the slicer autodecides usually
23:39:30 < buZz> well, not some, a range
23:40:36 < ccecil> buZz: yeah...w/t is what prusa's calculator uses as well IIRC
23:44:16 < buZz> prusa also said this on the calculator;
23:44:17 < buZz> WOH smaller than 2.0 produces weak parts.
23:44:17 < buZz> WOH bigger than 3 decreases the detail of printed part, because of thick line.