SHARE
TWEET

hame A5

a guest May 21st, 2013 179 Never
Not a member of Pastebin yet? Sign Up, it unlocks many cool features!
  1. U-Boot 1.1.7 (Dec 13 2011 - 13:49:42)
  2.  
  3.  
  4. Board: Ralink APSoC DRAM:   8 MB
  5.  
  6. relocate_code Pointer at: 807b4000
  7.  
  8. spi_wait_nsec: 42
  9.  
  10. spi device id: 7f 9d 46 7f 9d (9d467f9d)
  11.  
  12. Warning: un-recognized chip ID, please update bootloader!
  13.  
  14. raspi_read: from:30000 len:1000
  15.  
  16. .*** Warning - bad CRC, using default environment
  17.  
  18.  
  19. ============================================
  20.  
  21. Ralink UBoot Version: 3.6.0.0
  22.  
  23. --------------------------------------------
  24.  
  25. ASIC 5350_MP (Port5<->None)
  26.  
  27. DRAM_CONF_FROM: Boot-Strapping
  28.  
  29. DRAM_TYPE: SDRAM
  30.  
  31. DRAM_SIZE: 64 Mbits
  32.  
  33. DRAM_WIDTH: 16 bits
  34.  
  35. DRAM_TOTAL_WIDTH: 16 bits
  36.  
  37. TOTAL_MEMORY_SIZE: 8 MBytes
  38.  
  39. Flash component: SPI Flash
  40.  
  41. Date:Dec 13 2011  Time:13:49:42
  42.  
  43. ============================================
  44.  
  45. icache: sets:256, ways:4, linesz:32 ,total:32768
  46.  
  47. dcache: sets:128, ways:4, linesz:32 ,total:16384
  48.  
  49.  
  50.  ##### The CPU freq = 360 MHZ ####
  51.  
  52.  estimate memory size =8 Mbytes
  53.  
  54. raspi_read: from:40028 len:6
  55.  
  56. .
  57.  
  58. raspi_read: from:0 len:30004
  59.  
  60. ....*************Is_update = 0 plat = 1**************
  61.  
  62.  
  63. Please choose the operation:
  64.  
  65.    1: Load system code to SDRAM via TFTP.
  66.  
  67.    2: Load system code then write to Flash via TFTP.
  68.  
  69.    3: Boot system code via Flash (default).
  70.  
  71.    4: Entr boot command line interface.
  72.  
  73.    7: Load Boot Loader code then write to Flash via Serial.
  74.  
  75.    9: Load Boot Loader code then write to Flash via TFTP.
  76.  
  77.  
  78.  
  79. You choosed 3
  80.  
  81.  
  82.  0
  83.  
  84.    
  85.  
  86. 3: System Boot system code via Flash.
  87.  
  88. ## Booting image at bc050000 ...
  89.  
  90. raspi_read: from:50000 len:40
  91.  
  92. .   Image Name:   Linux Kernel Image
  93.  
  94.    Created:      2012-08-17   7:18:41 UTC
  95.  
  96.    Image Type:   MIPS Linux Kernel Image (lzma compressed)
  97.  
  98.    Data Size:    3766250 Bytes =  3.6 MB
  99.  
  100.    Load Address: 80000000
  101.  
  102.    Entry Point:  80244000
  103.  
  104. raspi_read: from:50040 len:3977ea
  105.  
  106. ..........................................................   Verifying Checksum ... OK
  107.  
  108.    Uncompressing Kernel Image ... OK
  109.  
  110. No initrd
  111.  
  112. ## Transferring control to Linux (at address 80244000) ...
  113.  
  114. ## Giving linux memsize in MB, 8
  115.  
  116.  
  117. Starting kernel ...
  118.  
  119.  
  120.  
  121. LINUX started...
  122.  
  123.  THIS IS ASIC
  124. Linux version 2.6.21 (root@localhost.localdomain) (gcc version 3.4.2) #128 Thu Aug 2 10:37:55 CST 2012
  125.  
  126.  The CPU frequency set to 360 MHz
  127. CPU revision is: 0001964c
  128. Determined physical RAM map:
  129.  memory: 01000000 @ 00000000 (usable)
  130. Built 1 zonelists.  Total pages: 4064
  131. Kernel command line: console=ttyS1,57600n8 root=/dev/mtdblock5
  132. Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.
  133. Primary data cache 16kB, 4-way, linesize 32 bytes.
  134. Synthesized TLB refill handler (20 instructions).
  135. Synthesized TLB load handler fastpath (32 instructions).
  136. Synthesized TLB store handler fastpath (32 instructions).
  137. Synthesized TLB modify handler fastpath (31 instructions).
  138. Cache parity protection disabled
  139. cause = c0808054, status = 11000000
  140. PID hash table entries: 64 (order: 6, 256 bytes)
  141. calculating r4koff... 0015f900(1440000)
  142. CPU frequency 360.00 MHz
  143. Using 180.000 MHz high precision timer.
  144. Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
  145. Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
  146. Memory: 13720k/16384k available (2021k kernel code, 2664k reserved, 295k data, 112k init, 0k highmem)
  147. Mount-cache hash table entries: 512
  148. NET: Registered protocol family 16
  149. usbcore: registered new interface driver usbfs
  150. usbcore: registered new interface driver hub
  151. usbcore: registered new device driver usb
  152. NET: Registered protocol family 2
  153. Time: MIPS clocksource has been installed.
  154. IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
  155. TCP established hash table entries: 512 (order: 0, 4096 bytes)
  156. TCP bind hash table entries: 512 (order: -1, 2048 bytes)
  157. TCP: Hash tables configured (established 512 bind 512)
  158. TCP reno registered
  159. deice id : 7f 9d 46 7f 9d (9d467f9d)
  160. Warning: un-recognized chip ID, please update SPI driver!
  161. AT25DF321(1f 47000000) (4096 Kbytes)
  162. mtd .name = raspi, .size = 0x00400000 (4M) .erasesize = 0x00010000 (64K) .numeraseregions = 0
  163. Creating 7 MTD partitions on "raspi":
  164. 0x00000000-0x00400000 : "ALL"
  165. 0x00000000-0x00030000 : "Bootloader"
  166. 0x00030000-0x00040000 : "Config"
  167. 0x00040000-0x00050000 : "Factory"
  168. 0x00050000-0x0011282a : "Kernel"
  169. mtd: partition "Kernel" doesn't end on an erase block -- force read-only
  170. 0x0011282a-0x01000000 : "RootFS"
  171. mtd: partition "RootFS" extends beyond the end of device "raspi" -- size truncated to 0x2ed7d6
  172. mtd: partition "RootFS" doesn't start on an erase block boundary -- force read-only
  173. 0x00050000-0x01000000 : "Kernel_RootFS"
  174. mtd: partition "Kernel_RootFS" extends beyond the end of device "raspi" -- size truncated to 0x3b0000
  175. RT3xxx EHCI/OHCI init.
  176. squashfs: version 3.2-r2 (2007/01/15) Phillip Lougher
  177. squashfs: LZMA suppport for slax.org by jro
  178. fuse init (API version 7.8)
  179. io scheduler noop registered (default)
  180. Hame plat 1
  181. Ralink gpio driver initialized [003c4001]
  182. HDLC line discipline: version $Revision: 1.1.1.1 $, maxframe=4096
  183. N_HDLC line discipline registered.
  184. Serial: 8250/16550 driver $Revision: 1.8 $ 2 ports, IRQ sharing disabled
  185. serial8250: ttyS0 at I/O 0xb0000500 (irq = 37) is a 16550A
  186. serial8250: ttyS1 at I/O 0xb0000c00 (irq = 12) is a 16550A
  187. loop: loaded (max 8 devices)
  188. rdm_major = 253
  189. Ralink APSoC Ethernet Driver Initilization. v2.1  256 rx/tx descriptors allocated, mtu = 1500!
  190. MAC_ADRH -- : 0x00009c41
  191. MAC_ADRL -- : 0x7c676020
  192. PROC INIT OK!
  193. IMQ starting with 2 devices...
  194. IMQ driver loaded successfully.
  195.         Hooking IMQ after NAT on PREROUTING.
  196.         Hooking IMQ before NAT on POSTROUTING.
  197. PPP generic driver version 2.4.2
  198. PPP BSD Compression module registered
  199. NET: Registered protocol family 24
  200. PPPoL2TP kernel driver, V0.17
  201. PPTP driver version 0.8.1
  202. tun: Universal TUN/TAP device driver, 1.6
  203. tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com>
  204. block2mtd: version $Revision: 1.1.1.1 $
  205. usbcore: registered new interface driver cdc_acm
  206. drivers/usb/class/cdc-acm.c: v0.25:USB Abstract Control Model driver for USB modems and ISDN adapters
  207. usbcore: registered new interface driver usbhid
  208. drivers/usb/input/hid-core.c: v2.6:USB HID core driver
  209. nf_conntrack version 0.5.0 (128 buckets, 1024 max)
  210. ip_tables: (C) 2000-2006 Netfilter Core Team, Type=Restricted Cone
  211. TCP cubic registered
  212. NET: Registered protocol family 1
  213. NET: Registered protocol family 17
  214. 802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
  215. All bugs added by David S. Miller <davem@redhat.com>
  216. VFS: Mounted root (squashfs filesystem) readonly.
  217. Freeing unused kernel memory: 112k freed
  218.  
  219. init started: BusyBox v1.12.1 (2011-10-22 23:04:50 CST)
  220.  
  221. starting pid 14, tty '': '/etc_ro/rcS'
  222. Algorithmics/MIPS FPU Emulator v1.5
  223. devpts: called with bogus options
  224. -------------------------------------------
  225. Welcome to
  226.         __  __     __     __    __  ______
  227.         | | | |   /  \   |  \  /  | | ____|
  228.         | |_| |  / /\ \  | |\\//| | | |___
  229.         |  _  | |_/__\ \ | | \/ | | | |___|
  230.         | | | | | |  | | | |    | | | |___
  231.         |_| |_| |_|  |_| |_|    |_| |_____|
  232.         HameData Technology Co., Ltd
  233. -------------------------------------------
  234. killall: goahead: no process killed
  235. usbcore: registered new interface driver ipheth
  236. Start gpio 0 monitor
  237. g_iplat = 1
RAW Paste Data
We use cookies for various purposes including analytics. By continuing to use Pastebin, you agree to our use of cookies as described in the Cookies Policy. OK, I Understand
Not a member of Pastebin yet?
Sign Up, it unlocks many cool features!
 
Top