#define _XTAL_FREQ 8000000

#define RS RD2
#define EN RD3
#define D4 RD4
#define D5 RD5
#define D6 RD6
#define D7 RD7

#include <xc.h>
#include "lcd.h";

// BEGIN CONFIG
#pragma config FOSC = HS // Oscillator Selection bits (HS oscillator)
#pragma config WDTE = OFF // Watchdog Timer Enable bit (WDT enabled)
#pragma config PWRTE = OFF // Power-up Timer Enable bit (PWRT disabled)
#pragma config BOREN = ON // Brown-out Reset Enable bit (BOR enabled)
#pragma config LVP = OFF // Low-Voltage (Single-Supply) In-Circuit Serial Programming Enable bit (RB3 is digital I/O, HV on MCLR must be used for programming)
#pragma config CPD = OFF // Data EEPROM Memory Code Protection bit (Data EEPROM code protection off)
#pragma config WRT = OFF // Flash Program Memory Write Enable bits (Write protection off; all program memory may be written to by EECON control)
#pragma config CP = OFF // Flash Program Memory Code Protection bit (Code protection off)
//END CONFIG 

int main()
{
    unsigned int a;
    TRISD = 0x00;
    Lcd_Init();
    while(1)
    {
        Lcd_Clear();
        Lcd_Set_Cursor(1,1);
        Lcd_Write_String("Thundertronics");
        Lcd_Set_Cursor(2,1);
        Lcd_Write_String("electronics blog");
        __delay_ms(3000);
        Lcd_Clear();
        Lcd_Set_Cursor(1,1);
        Lcd_Write_String("Welcome to");
        Lcd_Set_Cursor(2,1);
        Lcd_Write_String("PIC MCU course");
        __delay_ms(3000);
        

        

    }
    return 0;
}