=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2020.09.24 22:03:23 =~=~=~=~=~=~=~=~=~=~=~=
ping 10.1.1.254
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.1.1.254, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
SW-1#ping 10.10.10.254
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.10.10.254, timeout is 2 seconds:
.!!!!
Success rate is 80 percent (4/5), round-trip min/avg/max = 3/4/8 ms
SW-1#ping 20.20.20.254
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 20.20.20.254, timeout is 2 seconds:
.!!!!
Success rate is 80 percent (4/5), round-trip min/avg/max = 2/3/6 ms
SW-1#ping 30.30.30.254
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 30.30.30.254, timeout is 2 seconds:
.!!!!
Success rate is 80 percent (4/5), round-trip min/avg/max = 3/3/4 ms
SW-1#sh run
Building configuration...

Current configuration : 3804 bytes
!
! Last configuration change at 21:02:13 UTC Thu Sep 24 2020
!
version 15.2
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
service compress-config
!
hostname SW-1
!
boot-start-marker
boot-end-marker
!
!
enable secret 5 $1$N113$6YYR.pOBl8xXumcvXr0Bx.
!
no aaa new-model
!
!
!
!
!
!
!
!
ip cef
no ipv6 cef
!
!
!
spanning-tree mode pvst
spanning-tree extend system-id
!
!
! 
!
!
!
!
!
!
!
!
!
!
!
!
interface GigabitEthernet0/0
 switchport trunk allowed vlan 1,10,20,30
 switchport trunk encapsulation dot1q
 switchport mode trunk
 no negotiation auto
!
interface GigabitEthernet0/1
 switchport access vlan 10
 negotiation auto
!
interface GigabitEthernet0/2
 switchport access vlan 20
 negotiation auto
!
interface GigabitEthernet0/3
 switchport access vlan 30
 negotiation auto
!
interface GigabitEthernet1/0
 negotiation auto
!
interface GigabitEthernet1/1
 negotiation auto
!
interface GigabitEthernet1/2
 negotiation auto
!
interface GigabitEthernet1/3
 negotiation auto
!
interface GigabitEthernet2/0
 negotiation auto
!
interface GigabitEthernet2/1
 negotiation auto
!
interface GigabitEthernet2/2
 negotiation auto
!
interface GigabitEthernet2/3
 negotiation auto
!
interface GigabitEthernet3/0
 negotiation auto
!
interface GigabitEthernet3/1
 negotiation auto
!
interface GigabitEthernet3/2
 negotiation auto
!
interface GigabitEthernet3/3
 negotiation auto
!
interface Vlan1
 ip address 10.1.1.1 255.255.255.0
!
interface Vlan10
 ip address 10.10.10.1 255.255.255.0
!
interface Vlan20
 ip address 20.20.20.1 255.255.255.0
!
interface Vlan30
 ip address 30.30.30.1 255.255.255.0
!
ip default-gateway 10.1.1.254
ip forward-protocol nd
!
ip http server
!
ip ssh server algorithm encryption aes128-ctr aes192-ctr aes256-ctr
ip ssh client algorithm encryption aes128-ctr aes192-ctr aes256-ctr
!
!
!
!
!
!
control-plane
!
banner exec ^C
**************************************************************************
* IOSv is strictly limited to use for evaluation, demonstration and IOS  *
* education. IOSv is provided as-is and is not supported by Cisco's      *
* Technical Advisory Center. Any use or disclosure, in whole or in part, *
* of the IOSv Software or Documentation to any third party for any       *
* purposes is expressly prohibited except as otherwise authorized by     *
* Cisco in writing.                                                      *
**************************************************************************^C
banner incoming ^C
**************************************************************************
* IOSv is strictly limited to use for evaluation, demonstration and IOS  *
* education. IOSv is provided as-is and is not supported by Cisco's      *
* Technical Advisory Center. Any use or disclosure, in whole or in part, *
* of the IOSv Software or Documentation to any third party for any       *
* purposes is expressly prohibited except as otherwise authorized by     *
* Cisco in writing.                                                      *
**************************************************************************^C
banner login ^C
**************************************************************************
* IOSv is strictly limited to use for evaluation, demonstration and IOS  *
* education. IOSv is provided as-is and is not supported by Cisco's      *
* Technical Advisory Center. Any use or disclosure, in whole or in part, *
* of the IOSv Software or Documentation to any third party for any       *
* purposes is expressly prohibited except as otherwise authorized by     *
* Cisco in writing.                                                      *
**************************************************************************^C
!
line con 0
line aux 0
line vty 0 4
 password cisco
 login
!
!
end

SW-1#