code

//ARDUINO CODE.   Copy and paste in Arduino IDE

// MPU 6050   --->   Arduino
//
//  VCC   ----->   3.3v
//  GND   ----->   GND
//  SCL   ----->   A5 pin
//  SDA   ----->   A4 pin


#include<Wire.h>
const int MPU=0x68;  // I2C address of the MPU-6050
int16_t AcX,AcY,AcZ,Tmp,GyX,GyY,GyZ;

// value returned is in interval [-32768, 32767] so for normalize multiply GyX and others for gyro_normalizer_factor
// float gyro_normalizer_factor = 1.0f / 32768.0f;

void setup(){
  Wire.begin();
  Wire.beginTransmission(MPU);
  Wire.write(0x6B);  // PWR_MGMT_1 register
  Wire.write(0);     // set to zero (wakes up the MPU-6050)
  Wire.endTransmission(true);
  Serial.begin(9600);
}


void loop(){
  Wire.beginTransmission(MPU);
  Wire.write(0x3B);  // starting with register 0x3B (ACCEL_XOUT_H)
  Wire.endTransmission(false);
  Wire.requestFrom(MPU,14,true);  // request a total of 14 registers
  AcX=Wire.read()<<8|Wire.read();  // 0x3B (ACCEL_XOUT_H) & 0x3C (ACCEL_XOUT_L)
  AcY=Wire.read()<<8|Wire.read();  // 0x3D (ACCEL_YOUT_H) & 0x3E (ACCEL_YOUT_L)
  AcZ=Wire.read()<<8|Wire.read();  // 0x3F (ACCEL_ZOUT_H) & 0x40 (ACCEL_ZOUT_L)
  Tmp=Wire.read()<<8|Wire.read();  // 0x41 (TEMP_OUT_H) & 0x42 (TEMP_OUT_L)
  GyX=Wire.read()<<8|Wire.read();  // 0x43 (GYRO_XOUT_H) & 0x44 (GYRO_XOUT_L)
  GyY=Wire.read()<<8|Wire.read();  // 0x45 (GYRO_YOUT_H) & 0x46 (GYRO_YOUT_L)
  GyZ=Wire.read()<<8|Wire.read();  // 0x47 (GYRO_ZOUT_H) & 0x48 (GYRO_ZOUT_L)


  Serial.print(AcX); Serial.print(";"); Serial.print(AcY); Serial.print(";"); Serial.print(AcZ); Serial.print(";");
  Serial.print(GyX); Serial.print(";"); Serial.print(GyY); Serial.print(";"); Serial.print(GyZ); Serial.println("");
  Serial.flush();

  delay(25);
}