2kom link

#ethtool  eth2
Settings for eth2:
        Supported ports: [ TP ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Supported pause frame use: No
        Supports auto-negotiation: Yes
        Advertised link modes:  10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Advertised pause frame use: No
        Advertised auto-negotiation: Yes
        Speed: 1000Mb/s
        Duplex: Full
        Port: Twisted Pair
        PHYAD: 0
        Transceiver: internal
        Auto-negotiation: on
        MDI-X: Unknown
        Supports Wake-on: pumbg
        Wake-on: g
        Current message level: 0x00000033 (51)
                               drv probe ifdown ifup
        Link detected: yes

# ifconfig eth2
eth2      Link encap:Ethernet  HWaddr xx:xx:xx:xx:xx:xx
          inet addr:188.xxx.34.xxx  Bcast:188.xxx.34.255  Mask:255.255.255.0
          inet6 addr: fe80::5ed9:98ff:fef5:df56/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:2261957191 errors:0 dropped:0 overruns:0 frame:0
          TX packets:3011329170 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:10000
          RX bytes:2045390918 (1.9 GiB)  TX bytes:4211894059 (3.9 GiB)
          Interrupt:44 Base address:0x8000