40T



U-Boot SPL 2013.01.01-00006-gef50daa (Feb 01 2013 - 11:44:58)
OMAP SD/MMC: 0
reading u-boot.img
reading u-boot.img


U-Boot 2013.01.01-00006-gef50daa (Feb 01 2013 - 11:44:58)

OMAP3530-GP ES2.1, CPU-OPP2, L3-165MHz, Max CPU Clock 600 mHz
OMAP3 Beagle board + LPDDR/NAND
I2C:   ready
DRAM:  128 MiB
NAND:  256 MiB
MMC:   OMAP SD/MMC: 0
*** Warning - bad CRC, using default environment

In:    serial
Out:   serial
Err:   serial
Beagle Rev Ax/Bx
Recognized Tincantools Zippy2 board (rev 1)
No EEPROM on expansion board
Die ID #7f8400020000000004013ef10100c01d
musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, bulk combine, bulk split, HB-ISO Rx, HB-ISO Tx, SoftConn)
musb-hdrc: MHDRC RTL version 1.400
musb-hdrc: setup fifo_mode 4
musb-hdrc: 28/31 max ep, 16384/16384 memory
USB Peripheral mode controller at 480ab000 using PIO, IRQ 0
Net:   usb_ether
Hit any key to stop autoboot:  0
mmc0 is current device
gpio: pin 173 (gpio 173) value is 1
gpio: pin 7 (gpio 7) value is 0
SD/MMC found on device 0
reading uEnv.txt
1096 bytes read in 5 ms (213.9 KiB/s)
Loaded environment from uEnv.txt
Importing environment from mmc ...

Installer for [quantal-armhf] is using the Video Interface
Use [--serial-mode] to force Installing over the Serial Interface

reading zImage.net
3419824 bytes read in 2529 ms (1.3 MiB/s)
reading initrd.net