Advertisement
Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- *** DiskCheckup V3.1 Build: 1001 Report ***
- SysInfo DLL Version: SysInfo v1.0 Build: 1014
- Time of export: 20:10:10 22-févr.-2012
- Device information:
- Device ID: 1
- Interface: ATA
- Device Capacity: 305242 MB
- Serial Number: WD-WCAT15694986
- Model Number: WDC WD3200AAKS-00B3A0
- Firmware Revision: 01.03A01
- Partitions:
- E: 305242 MB
- ATA information:
- Disk geometry:
- Cylinders: 38913
- Tracks/Cylinder: 255
- Sectors/Track: 63
- Bytes/Sector: 512
- Total disk sectors: 625142448
- Logical sector size: 512
- Physical sector size: 512
- Media rotation rate: N/A
- Buffer size: 16384 KB
- ECC size: 50 Bytes
- Standards compliance:
- ATA8-ACS Supported: Yes
- ATA/ATAPI-7 Supported: Yes
- ATA/ATAPI-6 Supported: Yes
- ATA/ATAPI-5 Supported: Yes
- ATA/ATAPI-4 Supported: Yes
- Serial/Parallel: Serial
- SATA 3.0 Compilance: No
- SATA 2.6 Compilance: No
- SATA 2.5 Compilance: Yes
- SATA II: Ext Compilance: Yes
- SATA 1.0a Compilance: Yes
- ATA8-AST Compilance: No
- World Wide ID: 50014EE156BEA56B
- Feature support:
- SMART supported: Yes
- SMART enabled: No
- SMART self-test supported: Yes
- SMART error log supported: Yes
- LBA supported: Yes
- IORDY supported: Yes
- CFast supported: No
- DMA supported: Yes
- Maximum Multiword DMA mode supported: 2
- Multiword DMA selected: None
- Maximum UltraDMA mode supported: 6
- UltraDMA selected: 5
- Maximum PIO mode supported: 4
- SATA Compliance: Yes
- NCQ priority information supported: No
- Unload while NCQ commands are outstanding supported: No
- Phy Event Counters supported: Yes
- Receipt of power management requests supported: Yes
- NCQ feature set supported: Yes
- SATA Gen2 Signaling Speed (3.0Gb/s) supported: Yes
- SATA Gen1 Signaling Speed (1.5Gb/s) supported: Yes
- Software Settings Preservation: Supported, Enabled
- In-order data delivery: Not supported
- Initiating power management: Not supported
- DMA Setup auto-activation: Supported, Disabled
- Non-zero buffer offsets: Not supported
- Trusted Computing supported: No
- Host Protected Area (HPA) supported: Yes
- Read look-ahead supported: Yes
- Read look-ahead enabled: Yes
- Write cache supported: Yes
- Write cache enabled: Yes
- Power management supported: Yes
- Security mode supported: Yes
- Security mode enabled: No
- Device Configuration Overlay (DCO) supported: Yes
- 48bit Addressing supported: Yes
- Auto Acoustic Managment (AAM) supported: Yes
- Auto Acoustic Managment (AAM) enabled: No
- Power-up in Standby (PUIS) supported: Yes
- Power-up in Standby (PUIS) enabled: No
- Advanced Power Management (APM) supported: No
- CompactFlash Association (CFA) supported: No
- General Purpose Logging (GPL) supported: Yes
- Streaming supported: No
- Media card pass through supported: No
- Extended power conditions supported: No
- Extended status reporting supported: No
- Write-read-verify supported: No
- Free-fall control supported: No
- TRIM command supported: No
- SCT command transport supported: Yes
- NV Cache enabled: No
- NV Cache Power Management supported: No
- SMART ATTRIBUTES:
- ID Description Status Value Worst Threshold Raw Value TEC
- ---------------------------------------------------------------------------------------------------------------------------------------------
- 1 Raw Read Error Rate OK 200 200 51 0 N.A.
- 3 Spin Up Time OK 159 157 21 3041 N.A.
- 4 Start/Stop Count OK 99 99 0 1324 N.A.
- 5 Reallocated Sector Count OK 200 200 140 0 N.A.
- 7 Seek Error Rate OK 100 253 0 0 N.A.
- 9 Power On Time OK 88 88 0 9212 N.A.
- 10 Spin Retry Count OK 100 100 0 0 N.A.
- 11 Calibration Retry Count OK 100 100 0 0 N.A.
- 12 Power Cycle Count OK 99 99 0 1322 N.A.
- 192 Power off Retract Count OK 200 200 0 121 N.A.
- 193 Load Cycle Count OK 200 200 0 1324 N.A.
- 194 Temperature OK 106 96 0 37 C N.A.
- 196 Reallocation Event Count OK 200 200 0 0 N.A.
- 197 Current Pending Sector Count OK 200 200 0 0 N.A.
- 198 Uncorrectable Sector Count OK 200 200 0 0 N.A.
- 199 UltraDMA CRC Error Count OK 200 200 0 0 N.A.
- 200 Write Error Count OK 200 200 0 0 N.A.
- SMART HISTORY:
- Error retrieving history
Advertisement
Add Comment
Please, Sign In to add comment
Advertisement