Advertisement
Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- Ender 3 Changes
- - For XYZ cube issues
- - For XYZ cube change concentric infill pattern for top layer to zig zag to fix Z layer issue
- - Fix for "Ringing" issue - due to weight of glass bed change the "Jerk" setting from default 20 to 10 or 5
- - Fix for "Ringing" issue - also check acceleration - may help to reduce to 250-300
- - Fix for "Ringing" issue - check to see if changing "Wall Line Count (Perimeters)" to 3 - 4
- - Check eccentric nuts on Y-axis to ensure it's tight
- - Bed adhesion
- - Add a "G4 P<milliseconds>" gcode after an M190 command to heat bed then wait for a couple minutes:
- - M190 S60 ; heat bed to 60 and wait for temp
- - G4 P120000 ; wait for 2 minutes (to make sure the top of glass is heated)
- - The G4 wait can be added at the top of the Cura start gcode and it should heat B/E first then perform G4 wait
- - Part cooling fan
- - Ensure that Cura is set to run the fan at 100% after the initial layer - initial layer needs to go down with no fan to adhere better
Advertisement
Add Comment
Please, Sign In to add comment
Advertisement