printer.cfg cr10s

[stepper_x]
step_pin: ar54
dir_pin: ar55
enable_pin: !ar38
step_distance: .0125
endstop_pin: ^ar3
position_endstop: 0
position_max: 300
homing_speed: 50


[stepper_y]
step_pin: ar60
dir_pin: ar61
enable_pin: !ar56
step_distance: .0125
endstop_pin: ^ar14
position_endstop: 0
position_max: 300
homing_speed: 50

[stepper_z]
step_pin: ar46
dir_pin: !ar48
enable_pin: !ar62
step_distance: .0025
endstop_pin: ^ar18
position_endstop: 0.5
position_max: 400

[extruder]
step_pin: ar26
dir_pin: ar28
enable_pin: !ar24
step_distance: .010526
nozzle_diameter: 0.400
filament_diameter: 1.750
heater_pin: ar10
sensor_type: EPCOS 100K B57560G104F
sensor_pin: analog13
control: pid
pid_Kp: 22.2
pid_Ki: 1.08
pid_Kd: 114
min_temp: 0
max_temp: 250

[heater_bed]
heater_pin: ar8
sensor_type: ATC Semitec 104GT-2
sensor_pin: analog14
control: pid
pid_Kp: 690.34
pid_Ki: 111.47
pid_Kd: 1068.83
min_temp: 0
max_temp: 130

[fan]
pin: ar9

[mcu]
serial: /dev/ttyUSB0
pin_map: arduino

[printer]
kinematics: cartesian
max_velocity: 300
max_accel: 3000
max_z_velocity: 5
max_z_accel: 100

[display]
lcd_type: st7920
cs_pin: ar16
sclk_pin: ar23
sid_pin: ar17
encoder_pins: ^ar33, ^ar31
click_pin: ^!ar35


#[tmc2208 stepper_x]
#uart_pin: ar63
#tx_pin: ar40
#microsteps: 16
#interpolate: True
#run_current: 0.650
#hold_current: 0.650
#sense_resistor: 0.110
#stealthchop_threshold: 200

#[tmc2208 stepper_y]
#uart_pin: ar64
#tx_pin: ar59
#microsteps: 16
#interpolate: True
#run_current: 0.650
#hold_current: 0.650
#sense_resistor: 0.110
#stealthchop_threshold: 200

#[tmc2208 stepper_z]
#uart_pin: ar65
#tx_pin: ar42
#microsteps: 16
#interpolate: True
#run_current: 0.900
#hold_current: 0.900
#sense_resistor: 0.110
#stealthchop_threshold: 200