Advertisement
Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- root@OpenWrt:~# iw list
- Wiphy phy1
- wiphy index: 1
- max # scan SSIDs: 4
- max scan IEs length: 2304 bytes
- max # sched scan SSIDs: 0
- max # match sets: 0
- Retry short limit: 7
- Retry long limit: 4
- Coverage class: 0 (up to 0m)
- Device supports AP-side u-APSD.
- Device supports T-DLS.
- Available Antennas: TX 0x3 RX 0x3
- Configured Antennas: TX 0x3 RX 0x3
- Supported interface modes:
- * IBSS
- * managed
- * AP
- * AP/VLAN
- * monitor
- * mesh point
- * P2P-client
- * P2P-GO
- Band 2:
- Capabilities: 0x1ff
- RX LDPC
- HT20/HT40
- SM Power Save disabled
- RX Greenfield
- RX HT20 SGI
- RX HT40 SGI
- TX STBC
- RX STBC 1-stream
- Max AMSDU length: 3839 bytes
- No DSSS/CCK HT40
- Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
- Minimum RX AMPDU time spacing: No restriction (0x00)
- HT TX/RX MCS rate indexes supported: 0-15
- VHT Capabilities (0x338001f8):
- Max MPDU length: 3895
- Supported Channel Width: 160 MHz, 80+80 MHz
- RX LDPC
- short GI (80 MHz)
- short GI (160/80+80 MHz)
- TX STBC
- RX antenna pattern consistency
- TX antenna pattern consistency
- VHT RX MCS set:
- 1 streams: MCS 0-9
- 2 streams: MCS 0-9
- 3 streams: not supported
- 4 streams: not supported
- 5 streams: not supported
- 6 streams: not supported
- 7 streams: not supported
- 8 streams: not supported
- VHT RX highest supported: 0 Mbps
- VHT TX MCS set:
- 1 streams: MCS 0-9
- 2 streams: MCS 0-9
- 3 streams: not supported
- 4 streams: not supported
- 5 streams: not supported
- 6 streams: not supported
- 7 streams: not supported
- 8 streams: not supported
- VHT TX highest supported: 0 Mbps
- VHT extended NSS: not supported
- Frequencies:
- * 5180 MHz [36] (23.0 dBm)
- * 5200 MHz [40] (23.0 dBm)
- * 5220 MHz [44] (23.0 dBm)
- * 5240 MHz [48] (23.0 dBm)
- * 5260 MHz [52] (20.0 dBm) (radar detection)
- * 5280 MHz [56] (20.0 dBm) (radar detection)
- * 5300 MHz [60] (20.0 dBm) (radar detection)
- * 5320 MHz [64] (20.0 dBm) (radar detection)
- * 5500 MHz [100] (23.0 dBm) (radar detection)
- * 5520 MHz [104] (23.0 dBm) (radar detection)
- * 5540 MHz [108] (23.0 dBm) (radar detection)
- * 5560 MHz [112] (23.0 dBm) (radar detection)
- * 5580 MHz [116] (23.0 dBm) (radar detection)
- * 5600 MHz [120] (23.0 dBm) (radar detection)
- * 5620 MHz [124] (23.0 dBm) (radar detection)
- * 5640 MHz [128] (23.0 dBm) (radar detection)
- * 5660 MHz [132] (23.0 dBm) (radar detection)
- * 5680 MHz [136] (23.0 dBm) (radar detection)
- * 5700 MHz [140] (23.0 dBm) (radar detection)
- * 5720 MHz [144] (13.0 dBm) (radar detection)
- * 5745 MHz [149] (13.0 dBm)
- * 5765 MHz [153] (13.0 dBm)
- * 5785 MHz [157] (13.0 dBm)
- * 5805 MHz [161] (13.0 dBm)
- * 5825 MHz [165] (13.0 dBm)
- * 5845 MHz [169] (13.0 dBm)
- * 5865 MHz [173] (13.0 dBm)
- valid interface combinations:
- * #{ IBSS } <= 1, #{ managed, AP, mesh point, P2P-client, P2P-GO } <= 16,
- total <= 16, #channels <= 1, STA/AP BI must match
- HT Capability overrides:
- * MCS: ff ff ff ff ff ff ff ff ff ff
- * maximum A-MSDU length
- * supported channel width
- * short GI for 40 MHz
- * max A-MPDU length exponent
- * min MPDU start spacing
- max # scan plans: 1
- max scan plan interval: 0
- max scan plan iterations: 0
- Supported extended features:
- * [ VHT_IBSS ]: VHT-IBSS
- * [ RRM ]: RRM
- * [ SET_SCAN_DWELL ]: scan dwell setting
- * [ FILS_STA ]: STA FILS (Fast Initial Link Setup)
- * [ CQM_RSSI_LIST ]: multiple CQM_RSSI_THOLD records
- * [ CONTROL_PORT_OVER_NL80211 ]: control port over nl80211
- * [ TXQS ]: FQ-CoDel-enabled intermediate TXQs
- * [ AIRTIME_FAIRNESS ]: airtime fairness scheduling
- * [ AQL ]: Airtime Queue Limits (AQL)
- * [ CONTROL_PORT_NO_PREAUTH ]: disable pre-auth over nl80211 control port support
- * [ DEL_IBSS_STA ]: deletion of IBSS station support
- * [ SCAN_FREQ_KHZ ]: scan on kHz frequency support
- * [ CONTROL_PORT_OVER_NL80211_TX_STATUS ]: tx status for nl80211 control port support
- Wiphy phy0
- wiphy index: 0
- max # scan SSIDs: 4
- max scan IEs length: 2257 bytes
- max # sched scan SSIDs: 0
- max # match sets: 0
- Retry short limit: 7
- Retry long limit: 4
- Coverage class: 0 (up to 0m)
- Device supports AP-side u-APSD.
- Device supports T-DLS.
- Available Antennas: TX 0x3 RX 0x3
- Configured Antennas: TX 0x3 RX 0x3
- Supported interface modes:
- * IBSS
- * managed
- * AP
- * AP/VLAN
- * monitor
- * mesh point
- * P2P-client
- * P2P-GO
- Band 1:
- Capabilities: 0x1fe
- HT20/HT40
- SM Power Save disabled
- RX Greenfield
- RX HT20 SGI
- RX HT40 SGI
- TX STBC
- RX STBC 1-stream
- Max AMSDU length: 3839 bytes
- No DSSS/CCK HT40
- Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
- Minimum RX AMPDU time spacing: No restriction (0x00)
- HT TX/RX MCS rate indexes supported: 0-15
- Frequencies:
- * 2412 MHz [1] (20.0 dBm)
- * 2417 MHz [2] (20.0 dBm)
- * 2422 MHz [3] (20.0 dBm)
- * 2427 MHz [4] (20.0 dBm)
- * 2432 MHz [5] (20.0 dBm)
- * 2437 MHz [6] (20.0 dBm)
- * 2442 MHz [7] (20.0 dBm)
- * 2447 MHz [8] (20.0 dBm)
- * 2452 MHz [9] (20.0 dBm)
- * 2457 MHz [10] (20.0 dBm)
- * 2462 MHz [11] (20.0 dBm)
- * 2467 MHz [12] (20.0 dBm)
- * 2472 MHz [13] (20.0 dBm)
- * 2484 MHz [14] (disabled)
- valid interface combinations:
- * #{ IBSS } <= 1, #{ managed, AP, mesh point, P2P-client, P2P-GO } <= 4,
- total <= 4, #channels <= 1, STA/AP BI must match
- HT Capability overrides:
- * MCS: ff ff ff ff ff ff ff ff ff ff
- * maximum A-MSDU length
- * supported channel width
- * short GI for 40 MHz
- * max A-MPDU length exponent
- * min MPDU start spacing
- max # scan plans: 1
- max scan plan interval: -1
- max scan plan iterations: 0
- Supported extended features:
- * [ RRM ]: RRM
- * [ FILS_STA ]: STA FILS (Fast Initial Link Setup)
- * [ CQM_RSSI_LIST ]: multiple CQM_RSSI_THOLD records
- * [ CONTROL_PORT_OVER_NL80211 ]: control port over nl80211
- * [ TXQS ]: FQ-CoDel-enabled intermediate TXQs
- * [ SCAN_RANDOM_SN ]: use random sequence numbers in scans
- * [ SCAN_MIN_PREQ_CONTENT ]: use probe request with only rate IEs in scans
- * [ AIRTIME_FAIRNESS ]: airtime fairness scheduling
- * [ AQL ]: Airtime Queue Limits (AQL)
- * [ CONTROL_PORT_NO_PREAUTH ]: disable pre-auth over nl80211 control port support
- * [ DEL_IBSS_STA ]: deletion of IBSS station support
- * [ SCAN_FREQ_KHZ ]: scan on kHz frequency support
- * [ CONTROL_PORT_OVER_NL80211_TX_STATUS ]: tx status for nl80211 control port support
Advertisement
Add Comment
Please, Sign In to add comment
Advertisement