Advertisement
Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- A lot of guides say to start with Ifrit and use Flaming Crush
- at 15 second countdown to manipulate pet RNG involving
- Contagion, but from personal experience it doesn't seem to
- change anything. That may be a ping issue though, try it and
- see how things work out for you, but it's not *super*
- important.
- Pre countdown: Ifrit summoned and on Obey, Aetherflow full
- and cooldown below 35 seconds.
- Opener:
- -7s Summon Garuda
- -6s Radiant Shield (should cast before Garuda is summoned)
- -5s Diversion
- -4s Infusion of Intelligence
- -2.5s Ruin 3
- -1.5s Wind Blade
- PULL
- Ruin 2 > Tri-Disaster > Rouse
- Ruin 2 > Fester > Devotion (If you start far from the boss,
- try to stay close to melee and throw in a Heel somewhere
- in this GCD so Devotion actually hits people)
- Ruin 2 > Shadowflare > Painflare (Press Sic around here as
- soon as you see Devotion cast, Sic is faster than manually
- pressing Contagion, but using Sic too early will actually
- cancel Devotion)
- Ruin 2 > Fester > Dreadwyrm Trance
- Ruin 3 > Enkindle > Tri-Disaster
- Ruin 3 > Deathflare > Aetherflow
- Ruin 2 > Fester > Manashift (on BRD to extend Foes)
- Ruin 3
- Ruin 2 > Fester
- Ruin 3
- Ruin 2 > Fester
- Pre-DWT phase:
- Ruin 2 > Fester
- Ruin 3
- Ruin 2 > Fester
- Ruin 3
- Ruin 2 > Fester
- DWT phases:
- Ruin 2 > Dreadwyrm Trance > Tri-Disaster
- Ruin 3 x6 > Deathflare
- Bahamut:
- Ruin 2 > Aetherflow > Summon Bahamut
- Ruin 2 > Fester > Akh Morn
- Ruin 2
- Ruin 2 > Fester
- Ruin 2 > Addle
- Ruin 2 > Fester
- Ruin 2 > Tri-Disaster
- Ruin 2 > Akh Morn
- Ruin 2
- Notes:
- - Bio 3, Miasma 3, and Aetherflow are your golden timers.
- Keeping your dots up at all times and making sure Aetherflow
- is never off cooldown marks good SMN play, everything else is
- small optimization.
- - You actually have a lot of maneuverability with your
- rotation as SMN. There's no perfect time for your DWT phases
- that will be the same every fight, but the very latest you
- can start a DWT phase is when Aetherflow cooldown is on 16
- seconds. Any later and you risk leaving Aetherflow off
- cooldown and/or losing DWT time by using Deathflare early.
- That leaves you 45 seconds to decide the best time to use it.
- - That being said, in fights like O10S where there's a lot of
- downtime, getting Aetherflow back off cooldown is more
- important than getting the max out of DWT, use Deathflare ASAP
- in these situations.
- - Typically you want to be using Tri-Disaster to refresh your
- dots but that's not always possible. Hardcast them if DWT is
- not up and/or you need it for Bahamut phase.
- - We use Tri-Disaster and Addle with Bahamut to proc
- Wyrmwaves, always aim for 11 Wyrmwaves and 2 Akh Morn casts
- every Bahamut phase.
- - Between phases is as simple as casting Ruin 3 as much as
- possible. Only use Ruin 2 to weave in oGCDs. If you need to
- move, judge if you can wait until DWT to not lose Ruin 3
- casts.
- - Normally you're free to use Rouse on cooldown, but if
- Bahamut is less than 20 seconds away, wait until after Bahamut
- to use it. On that topic, Devotion and Enkindle have weird
- cast times, try not to risk using them less than a GCD before
- Bahamut.
- - Always watch for Ruin 4 procs, and replace ANY Ruin 3 or 2
- cast with it. Holding on to it for more than a GCD risks
- losing out on more possible procs.
- - Typically with where we press Sic in the opener, Contagion
- will line up just before Aetherflow, allowing it to be used
- with Fester phases and Bahamut. But more often than not,
- you won't have 100% uptime on the boss, so if Contagion comes
- off cooldown and the boss in untargetable or you're attacking
- an add, put Garuda on Obey until you can sync Contagion with
- those phases again.
- - In AoE situations, never underestimate Bane and Tri-bind.
- Bane passes the dots *AND* time remaining to other targets,
- so try to hold off dotting until you can freely use Bane
- straight after to maximize dot uptime on all targets. Tri-bind
- should replace Ruin 3 during DWT phases if there are 3 or more
- targets in range, don't use it outside of DWT unless you like
- not having MP.
Advertisement
Add Comment
Please, Sign In to add comment
Advertisement